Outdoor Leisure Td125, Td126, Td127, Td128 Owner's Manual page 6

6. Install tank door by placing cutouts on
sides over screws installed in step 5 (see
Figure 5).
7. Slide propane/LP cylinder top down pole
and over pole support (see Figure 6). Be
sure that propane/LP cylinder top rests
level on base.
Figure 5 - Attaching Tank Door
Cap Support
Figure 6 - Installing Cylinder Cap
6
aSSEMbLy
Continued
8. Remove 4 screws in bottom of emitter.
Cutout in
Tank Door
Figure 7 - Placing Burner Assembly Onto
Cylinder Cap
www.desatech.com
Note: A cap support is provided on pole
support to lift top when changing propane/
LP cylinder.
Place burner assembly on emitter and
align holes. Replace screws. See Figures
7 and 8.
Emitter
Figure 8 - Attaching Burner Assembly
and Emitter
Burner
Assembly
Emitter
121117-01B