Desa (F)SDVBNC Owner's Operation And Installation Manual page 6

CAST IRON STOVE AND DIRECT-VENT BURNER SYSTEM ASSEMBLY
6
Stove Body Assembly (Cont.)
CAST IRON STOVE AND
DIRECT-VENT BURNER
SYSTEM ASSEMBLY
Continued
6. Remove all contents from inside stove cavity. Contents include:
(1) - Stove bottom (Discard - Not used with this application)
(4) - Legs with leg leveler bolts
(1) - Bottom door
(3) - Top grates
(1) - Hardware kit bag with fasteners
7. Carefully lay stove body on back to attach bottom components to
stove body (see Figure 7). Rest stove on drop cloth or blanket to
avoid scratching stove edges.
8. Remove remaining pallet wood attached to bottom of stove
body (see Figure 8). Use an adjustable wrench to remove bolts.
9. Fasten each leg to stove with four (4) M8 x 1.25 - 20mm bolts.
Use a flat washer and lock washer with each bolt. Tighten bolts
into threaded holes on stove body (see Figures 9 and 10). Use
an adjustable wrench or a 12mm and 6mm socket.
10. Attach stove door by inserting step bolt through door hinge pivot
hole and into threaded hole in stove body (Figure 11 on page 7
and Figure 9). Use an adjustable wrench or a 12mm socket to
fasten step bolt. Tighten step bolt until snug. Make sure door
moves freely.
11. Install door catch bolt (M8 x 1.25-55mm with two M8 hex nuts)
into threaded hole on stove body (see Figure 9). Use an adjust-
able wrench or a 12mm socket. The catch bolt has two hex nuts
attached to it (see Figure 12, page 7). The top nut is a bolt stop
and the bottom nut is for door leveling adjustment.
12. Check general catch bolt alignment with door claw. Make
final adjustment and door leveling after stove is in normal
standing position.
13. Carefully lift stove back up on its four attached legs.
14. Remove 2 bolts from bottom of stove and discard. Remove
bolt from the top of the stove to remove the front panel assem-
bly (see Figure 13, page 7).
Top of Stove Unit
Front of
Stove
Unit
Pallet
Wood
Drop
Bolted to
Cloth/
Bottom of
Blanket
Stove Body
Figure 7 - Laying Down Stove On Side
For more information, visit www.desatech.com
For more information, visit www.desatech.com
Figure 8 - Removing Pallet Wood From The Bottom of The Stove
Bottom of
Stove Unit
Figure 9 - Locating Threaded Holes for Legs and Door Attachment
Top of
Front of
Stove
Stove Unit
Unit
Figure 10 - Attaching Stove Legs
Front
Bolt
Pallet
Wood
Door Hinge Step
Bolt Hole
Leg Hole
Washers
Bolt
Pallet
Wood
Bottom Of
Stove Unit
Door Catch Bolt
With Adjustable
Hex Nuts Hole
Front
Leg Hole
Leg Hole
Bottom Of
Stove Unit
Leg
107304