Desa VDCFRNA Owner's Operation And Installation Manual page 13

INSTALLATION
Continued
4. Place mantel around fireplace on base (see
Figure 12).
5. Assemble perimeter trim kit. See Assembling
Perimeter Trim.
6. Firmly snap perimeter trim kit on shoulder
screws. Shoulder screws are located on fire-
place cabinet (see Figure 12).
7. Align perimeter trim kit for flush fit around
opening.
8. Center mantel left to right on base making sure
mantel is flush against wall.
9. Use two 3" wood screws provided and attach
base of fireplace to wooden mantel base (see
Figure 12).
10. Remove perimeter trim kit and mantel. Be
careful not to damage wall or mantel.
11. Cut an access hole in base to run flexible gas
line to fireplace (see Figure 12). Make sure
to locate access hole so mantel will cover it
when installed. Note: You can secure base to
floor using wood screws. Countersink screw
heads and putty over.
Shoulder
Screw
Assembled
Hole for 3" Wood
Perimeter
Screw for Attaching
Trim
Fireplace to
Wooden Base
Figure 12 - Attaching Perimeter Trim to
Fireplace
113133-01B www.desatech.com 13