Sangean WFR-1 Quick Setup Manual

Connect the Sangean Internet Radio (WFR-1) either to wired or wireless LAN as shown below. This is the same
way your PC is connected to the internet.
* No PC is needed. PC needs to be turned on and connected to the router only when you would like to play music
loaded in your PC (Shared Folder or UPnP).
1. Turn on the router and the internet radio.
2. Connect the devices as the figure above.
3. Rotate and press the SELECT control (a knob) on
the radio to go to Main Menu -> System Setup ->
Internet Setup -> Wizard ->［Wired］
4. If there is password for the access point, input and
enter the password using the SELECT control.
Then radio will connect to the internet. Please read
the instruction manual for all the functions.
* If the wired connection is not working, after a few
seconds the display will change to show 'Scan for
networks'
* After setting up as above, the internet radio is connected to internet and ready to be operated. Rotate and press the
turning knob on the internet radio to operate the functions.
PROBLEMS:
CALL TOLL FREE 1-888-SANGEAN (726-4326)

Quick Setup Guide

1. Turn on the router with access point and power plug
the internet radio.
2. Connect the devices as the figure above.
3. Press the SELECT control (a knob) on the radio, it
will scan for networks and show all the detectable
access points' names.
4. Rotate and press the SELECT control to select your
access point. It can be your access point's model name
or a set up name.
5. If there is password for the access point, input and
enter the password using the SELECT control. Then
radio will connect to the internet. Please read the
instruction manual for all the functions.