Motec E816 Manual

MoTeC
Contents
Introduction ........................................................................ 1
Overview ............................................................................. 2
Inputs .................................................................................. 3
Input Pin Configuration (ADL) .............................................................................4
Outputs ............................................................................... 7
Output Configuration...........................................................................................7
E8xx Diagnostic Information .......................................... 11
Test Analogue Inputs ........................................................................................12
Test Auxiliary Outputs .......................................................................................12
Communications.............................................................. 14
CAN ..................................................................................................................14
Firmware Upgrades...........................................................................................14
Appendices....................................................................... 15
Appendix A: General Specifications ..................................................................15
Appendix B: Input Characteristics .....................................................................16
Appendix C: Output Characteristics ..................................................................18
Appendix D: CAN Wiring - Multiple Device.......................................................19
Appendix E: E8xx to ADL Wiring.......................................................................20
Appendix F: E8xx to M800 Wiring .....................................................................21
Appendix G: E888 Pin List by Pin Number........................................................22
Appendix H: E816 Pin List by Pin Number........................................................23
Appendix I: E816 Connector .............................................................................24
The information in this document is subject to change without notice.
While every effort is taken to ensure correctness, no responsibility will be taken for the consequences of any
© Copyright 2005 - Motec Pty Ltd
inaccuracies or omissions in this manual.
16 December, 2005
E888/816 Manual