Desa Comfort Glow CGCF26TNA Owner's Operation And Installation Manual page 4

VENT-FREE NATURAL GAS COMPACT FIREPLACE
ASSEMBLY
WARNING: Always have
branch support and screen in
place before operating fireplace.
This prevents excessive tempera-
tures on fireplace surfaces.
ASSEMBLING FIREPLACE
Tools Required:
• Phillips screwdriver
• 5/16" hex wrench
• slotted screwdriver
Installing Log
1. Remove back log, branch, and hood from
log box. Discard protective packaging.
2. Remove two shipping screws above
screen (see Figure 2).
3. Lift screen up and pull out to remove.
4. An optional blower is available. See Ac-
cessories, page 22. Install optional
blower now. Follow installation in-
structions provided with blower.
5. Gently place back log on burner sup-
port (see Figure 2). The log should fit
flat against top of burner support. Place
two #10 one-inch-long screws through
burner support into the log and tighten.
Place branches on branch support (see
Figure 2).
6. Reattach screen by placing notches in
screen frame over shoulder screws and
pushing down.
WARNING: Failure to position
the parts in accordance with these
diagrams or failure to use only
parts specifically approved with
this fireplace may result in prop-
erty damage or personal injury.
Back Log
Screw
Branch
Screen
Figure 2 - Assembling Fireplace
Assembling Hood
1. Locate four #10-3/8" black phillips
sheet metal screws from the hardware
packet.
3
2. Remove two 1 / " screws from under-
4
neath middle rail (see Figure 3).
3. Slip top of hood between middle rail and
top of firebox wrapper (see Figure 3).
Figure 3 - Assembling Hood
4
Screen
Shipping
Screw
Branch
Support
Screw
4. Reinstall two 1
step 2. Make sure screw pass through
hood and middle rail and attach into
upper louver assembly (see Figure 3).
5. Attach four #10-3/8" hood screws as
shown in Figure 3.
#10-3/8" Screws
Shoulder Screw
Burner
Support
3
/ " screws removed in
4
Middle Rail
Firebox
Wrapper
Hood
104277