American Audio SCRATCH BOX - SET UP Manual

Warning! Be sure to make all connections before powering the unit!
T U R N TA B L E
SB-12 Vinyl Record Only
CLK OUT
Scratch Box™ - The Scratch Box™ is compat-
ible with any turntable. The above diagram briefly
details set-up procedures.
Note:
The Scratch Box™ will only function with
the included SB-12 Blue Vinyl Record. Replace-
ment Vinyl is available from American Audio.
1
1. PHONO INPUTS - These are stereo phono
inputs. Connect a turntable's output RCAs to
these jacks. The right stereo channel is repre-
sented by the red female RCA and labeled with
"R."
2. PHONO GROUND - This ground connector is
used to extend the reach of the turntables ground
connector. Connect the turntable ground cable to
this connector to avoid hum and pops associated
with phono cartridges.
3. CHANNEL 2 CONTROL OUTPUT - This con-
trol jack is used to send the signal coming from
the turntable to the CD player. Connect this out-
put to the channel two scratch box insert on the
rear of the CD transport unit. Be sure to only use
the supplied stereo mini plugs. Using mono mini
plugs may cause your CD to play in reverse.
SCRATCH BOX SET UP
R
Scratch Box
CLK OUT
DC 12V
1 2
SCRATCH BOX DIGITAL
INPUT OUT
AC INPUT 115/230 V, 50/60 Hz
CONNECT TO
AUDIO OUT
CONTROL 2
Voltage Selector
R L
2
115V
GND
R L
American Audio
GND
L
Stereo Mini Plug Only
SCRATCH BOX DIGITAL
INPUT OUT
CONNECT TO
AUDIO OUT
CONTROL 1
R L
1
CAUTION
DCD-PRO610 ONLY
RISK OF ELECTRICAL SHOCK
230V
DO NOT OPEN
3
4
2
6
6
4. CHANNEL 1 CONTROL OUTPUT - This con-
trol jack is used to send the signal coming from
the turntable to the CD player. Connect this out-
put to the channel one scratch box insert on the
rear of the CD transport unit. Be sure to only use
the supplied stereo mini plugs. Using mono mini
plugs may cause your CD to play in reverse.
5. POWER SUPPLY INPUT - Connect the power
supply included with the unit to power the Scratch
Box. ™
6. PHONO OUTPUTS - These outputs are used
to send the turntable analog signal to your mixer.
The left channel is represented by the white RCA
connector, the red represents the right channel.
7. GROUND OUTPUT - Connect the turntable
ground cable to this connector to avoid hum and
pops associated with phono cartridges.
• INSTRUCTION MANUAL
®
Scratch Box
CLK OUT CLK OUT
DC 12V
1 2
GND
CLK OUT CLK OUT
DC 12V
1 2
R L
R L
5
7
GND