Advertisement
Advertisement
Table of Contents
Related Manuals for B2 Audio rage 3200
Summarization of Contents
Introduction and Product Line
RAGE Series Overview
Introduces the RAGE series as "The increased Desire for B2 audio", covering various amplifier types.
Electrical System Recommendations
Advises upgrading the stock electrical system for optimal amplifier performance and stability.
Design Features and Specifications
RAGE 1500/3200/1200.4 Specifications
Detailed technical specs including circuit, frequency response, SNR, sensitivity, crossovers, and dimensions.
Continuous Output Power (RMS)
Lists RMS output power for RAGE models at 4Ω, 2Ω, and 1Ω impedances.
Specification Explanations and Warnings
Clarifies operational conditions, protection modes, and battery requirements for safe use.
Panel Layout - RAGE 1500/3200
GND and +12V Power Connections
Instructions for secure ground and +12V power connections, including fuse placement.
Gain, Input, and Remote Connections
Details on adjusting gain, RCA input, and the switched 12V remote connection.
LED Indicators and Crossover Controls
Explains LED status lights and settings for HPF and LPF crossovers.
Speaker Output and Bridging
Information on speaker terminals, minimum load, and limitations on bridging/strapping.
Panel Layout - RAGE 1200.4
GND and +12V Power Connections
Instructions for secure ground and +12V power connections for the 1200.4 model.
Speaker Output and Bridging Options
Details on 4-channel speaker outputs, minimum loads, and bridging for the 1200.4.
Gain, Input, and Remote Connections
How to set gain, connect RCA inputs, and manage the remote turn-on signal.
LED Indicators and Crossover Settings
Explains LED indicators and controls for crossover type, HPF, and LPF.
Power and Speaker Connection - RAGE 1500/3200
Grounding and Fusing Guidelines
Emphasizes short ground connections and recommended ampere ratings with external fuses.
Speaker Output Wiring and Load
Instructions for connecting speakers to the 2-pin terminals and minimum load specifications.
Power and Speaker Connection - RAGE 1200.4
Grounding and Fusing for 1200.4
Recommendations for ground connections and fuse rating for the 1200.4 model.
Speaker Output Wiring and Load
Details on connecting speakers to the 4-channel outputs and minimum load requirements.
Important Installation Cautions
Critical steps and warnings for installation, including voltage limits and warranty voidance.
Installation Guide
Pre-Installation Considerations
General advice, preparation steps, and mounting location selection.
Connecting Power and Ground
Detailed instructions for 12V, ground, and remote turn-on connections.
Input Signal Wiring
Proper routing and connection of RCA cables to prevent noise interference.
Troubleshooting Common Issues
No Power or Protection Mode
Steps to diagnose why the amplifier won't turn on or is stuck in protection mode.
Fuse Blowing and Overheating
Identifies causes like impedance mismatch or shorts for blown fuses and overheating.
Audio Quality Problems
Solutions for distorted sound, low output, turn-on thump, and hiss/whine.
Limited Warranty Information
Warranty Terms and Coverage
Outlines the warranty period, conditions, exclusions, and return procedures.
Need help?
Do you have a question about the rage 3200 and is the answer not in the manual?
Questions and answers