Page 1
OPERATING INSTRUCTIONS for baths with Aqua-Comfort Always read the operating instructions carefully before using the bath with Aqua-Comfort! Make sure that you observe the care instructions! Repabad cannot be held liable for damages caused by inappropriate use.
Page 2
Introduction CONGRATULATIONS! ou have chosen an innovative, premium product from Repabad. Our products combine impressive technology with ease of use. Please read these operating instructions carefully, so that you can best use the bath with Aqua-Comfort to improve your well-being and enjoy the product for many years to come.
Table of contents 01 SAFETY INFORMATION 02 WELLNESS TIPS 03 DESIGN 04 BEFORE USE 05 DURING USE Safety shutdown Loudspeaker safety shutdown 06 AFTER USE 07 MANUAL BLOW-OUT 08 DISINFECTION 09 SERVICING Cleaning the nozzles 10 NOZZLE FUNCTION AND STRUCTURE 11 CLEANING THE DRAIN FILTER, ADJUSTING THE DRAIN PLUG 12 TROUBLESHOOTING TECHNICAL PROBLEMS 13 TECHNICAL DATA...
We recommend waiting until you have fully healed before using it. Only use Repabad bath additives. Using other bath additives risks damaging the Aqua-Comfort system. Depending on the frequency of use, you should disinfect the bath with Aqua-Comfort approximately every 4 weeks.
Operation 03 DESIGN The bath with Aqua-Comfort system is equipped with a fi xed fan installed under the bathtub and a jet pump. The Champagne nozzles (combined air and water nozzles) are located at the base of the bathtub. When the Aqua-Comfort system is activated, these nozzles convey preheated air from the fan into the bath, while the pump generates fi ne jets of water.
Usage / Disinfection Loudspeaker safety shutdown Whirlpool loudspeakers (a special accessory) are equipped with overload protection. If the volume of the connected music system is set too high, overload protection is activated. This results in the loudspeakers becoming considerably quieter or even being switched off. In this case, the volume of the music system must be reduced immediately.
Depending on the frequency of use, you should disinfect the bath roughly every 4 weeks. Only use Repabad disinfectant. If other agents are used, there is risk of damage to the bath. Make sure the bath is filled up to at least 5 cm above the nozzles before disinfection! - Add disinfectants to the water after bathing: Use approx.
Servicing / technical data CLEANING THE DRAIN FILTER, ADJUSTING THE DRAIN PLUG Remove the drain cover (4) together with the drain plug (5) by lifting it upwards Attention: The plug is only loosely fitted, it can fall out and damage the bath Clean the filter (6) You can adjust the drain plug using the adjustment screw (7) 12 TROUBLESHOOTING TECHNICAL PROBLEMS...
Bathing tips 14 HOW TO BATHE CORRECTLY WITH AQUA-COMFORT Immerse yourself in pleasantly hot water. The massage relaxes your muscles, relieving tension. It stimulates the metabolism, has a positive effect on the vegetative nervous system, the brain releases “happy hormones” – you feel good all over. We have compiled a few tips here that will help you better understand the positive effect of the Aqua-Comfort on body and mind, along with information on how to use these functions correctly.
Aromatherapeutic bath additives Bath additives from Repabad are ideally suited for use in baths with Aqua-Comfort and whirlpools, as they only foam a little and leave no deposits in the system. Their proportions of essential oils make them ideal care for the body and soothing to the soul.
Bathing tips / aromatherapy Effects of the bath additives The effects mentioned should only be viewed as examples, as the aromas have different effects on different people. REPABAD COMPLAINTS TEMPERATURE WHIRL TIME SPECIALITIES BATH ADDITIVES * 28°C or Boosting the Eucalyptus, 7 min.
Need help?
Do you have a question about the Sydney and is the answer not in the manual?
Questions and answers