ACRONIS BACKUP AND RECOVERY 10 ADVANCED SERVER SBS EDITION - COMMAND LINE REFERENCE UPDATE 3 Cli Reference Manual page 15

moment of taking the data snapshot. The data consistency, in turn, ensures that the application will
be recovered in the correct state and become operational immediately after recovery.
1.1.3.3 deploy
file_partition:[partition letter]
Specifies the partition where the image file will be stored (by letter or number). This option is used
with filename:[file_name]. In that case the file name must be specified without a drive letter or root
folder. For example:
/file_partition:D /filename:"\1.tib"
Dynamic volumes are specified with the prefix DYN, e.g.:
/file_partition:DYN1 /filename:"\1.tib"
harddisk:[disk number]
Specifies the basic hard disks to restore.
partition:[partition number]
Specifies the partitions to restore.
Dynamic volumes are specified with the prefix DYN, e.g.:
/partition:DYN1
target_harddisk:[disk number]
Specifies the hard disk number where the image will be restored.
By specifying
/target_harddisk:DYN
you will select unallocated space on all dynamic disks that are present in the system.
target_partition:[partition number]
Specifies the target partition number for restoring a partition over the existing one. If the option is
not specified, the program assumes that the target partition number is the same as the partition
number specified with the /partition option.
Dynamic volumes are specified with the prefix DYN, e.g.:
/target_partition:DYN1
start:[start sector]
Sets the start sector for restoring a partition to the hard disk unallocated space.
15 Copyright © Acronis, Inc., 2000-2010