Advertisement
OPERATING INSTRUCTIONS
1. Set the thermostat to the OFF position.
2. Plug in heater. The power light will illuminate and remain lit
when the heater is on.
3. For heater operation, set the Thermostat control all the way to HI.
4. Turn the Heat Setting Control to desired heat setting (LOW for
600W, MED for 900W, or HIGH for 1500W).
SETTING THE THERMOSTAT
1. Set the Thermostat control all the way to HI. (See fig. #2)
2. When the desired temperature/comfort level is reached, lower
the thermostat control setting until the heater stops operating.
3. The control will now automatically maintain the pre-set temperature
level by turning the heater ON and OFF.
Note: The Power light will remain lit during operation.
Note: It is normal for the heater to cycle ON and OFF
as it maintains the preset temperature. To prevent the
unit from cycling, you need to raise the thermostat setting.
CLEANING/MAINTENANCE
During Season Care:
1. Always unplug the heater before cleaning
2. Clean the unit with a soft damp cloth. Please be very
cautious near the metal fins.
3. NEVER use abrasive or flammable solvents to clean the unit.
4. After cleaning, be sure to completely dry the unit with a cloth
or towel.
After Season Care:
1. Store heater in a cool, dry location.
2. Holmes recommends that you store the unit
in its original carton.
TROUBLESHOOTING
If your heater fails to operate:
• UNPLUG THE UNIT
• Make sure the electrical outlet or circuit breaker is working.
• The temperature may be set too low. Turn the thermostat knob
clockwise until the heater restarts.
• Make sure selector is in LOW, MED or HIGH setting.
Please DO NOT attempt to open or repair the heater.
Please see the Warranty for Service Instructions.
ILLUSTRATIONS
Carry Handle
Cord Wrap
Figure 1
Carry Handle
Thermostat
Power Light
Figure 2
Figure 3
Easy Roll Wheels
OFF
I Lo 600W
II Med 900W
III Hi 1500W
MODE Control
Figure 4
Advertisement
