Table of Contents
Advertisement
VENT-FREE PROPANE COMPACT FIREPLACE
INSTALLATION
Continued
OPTIONAL WIRELESS
HAND-HELD REMOTE
CONTROL ACCESSORIES
(CGHRC Series and
CGHRCT Series)
Installing Receiver
1. Remove screws.
2. Disconnect switch wires from the con-
trol valve.
3. Remove switch plate (see Figure 22).
Discard switch plate after removing.
Save the screws.
4. Locate the battery clip mounted on the
back of the receiver (see Figure 23).
5. Slide 9-volt battery (not included)
through the clip.
6.
Attach the terminal wires to the battery
(see Figure 23).
7. Connect wires as shown in Figure 24.
8. Install remote receiver unit onto gas
heater base using the two screws re-
moved in step one (see Figure 24).
Screw
Black Wire
Heater Base
Figure 22 - Switch Plate and Wiring
Harness
Receiver
Figure 23 - Attaching Battery to Receiver
Black Wire
Wire Harness*
Wires from
Valve
Black Wire
Switch Plate
Figure 24 - Installing Remote Receiver
* Wire harness provided in the fireplace
Red Wire
hardware pack.
Terminal
Wires
Battery Clip
9-Volt Battery
Remote
Receiver
Red Wire
Red Wire
14
Installing 9-Volt Battery in Hand-
Held Remote Control Unit
1. Remove battery cover on back of re-
mote control unit.
2. Attach terminal wires to the battery (not
included). Place battery into the battery
housing.
3. Replace battery cover onto remote con-
trol unit.
Battery
Terminal
Cover
Wires
9-Volt
Battery
Figure 25 - Installing Battery in Hand-
Held Remote Control Unit
Remote
Control Unit
Battery
Housing
105616
Advertisement
Table of Contents
