Table of Contents
Advertisement
VENT-FREE NATURAL GAS COMPACT FIREPLACE
ASSEMBLY
WARNING: Always have
branch support and screen in
place before operating fireplace.
This prevents excessive tempera-
tures on fireplace surfaces.
ASSEMBLING FIREPLACE
Tools Required:
• Phillips screwdriver
• 5/16" hex wrench
• Slotted screwdriver
Installing Log
1. Remove back log, branch, and hood from
log box. Discard protective packaging.
2. Remove two shipping screws above
screen (see Figure 2).
3. Lift screen up and pull out to remove.
4. An optional blower is available. See Ac-
cessories, page 21. Install optional
blower now. Follow installation in-
structions provided with blower.
5. Gently place back log on burner sup-
port (see Figure 2). The log should fit
flat against top of burner support. Place
two #10 one-inch-long screws through
burner support into the log and tighten.
Place branche on branch support (see
Figure 2).
6. Do not allow branch to contact flame.
If flame contacts branch, soot will be
created.
7. Reattach screen by placing notches in
screen frame over shoulder screws and
pushing down.
WARNING: Failure to posi-
tion the parts in accordance with
these diagrams or failure to use
only parts specifically approved
with this fireplace may result in
property damage or personal injury.
CGCF26NR
Back Log
Branch
Screen
Figure 2 - Assembling Fireplace
Assembling Hood
1. Locate four #10-3/8" black phillips
sheet metal screws from the hardware
packet.
3
2. Remove two 1
/
" screws from under-
4
neath middle rail (see Figure 3).
3.
Slip top of hood between middle rail and
top of firebox wrapper (see Figure 3).
Figure 3 - Assembling Hood
4
Screen Shipping Screw
Screw
Screw
4. Reinstall two 1
step 2. Make sure screw pass through
hood and middle rail and attach into
upper louver assembly (see Figure 3).
5. Attach four #10-3/8" hood screws as
shown in Figure 3.
Middle Rail
2 Short
Screws
1
3
/
"
4
Screws
Shoulder Screw
Burner
Support
Branch Support
3
/
" screws removed in
4
Hood
Firebox Top
104326
Advertisement
Table of Contents
