Rj45 Connections - Russound UNO-TS2D Instruction Manual

RJ45 Connections

The CAT-5 T568A wiring standard is used for all
RJ45 terminations. This includes the RJ45 CAT-5
patch cable and the RJ45 wall plate connections.
Note: CAT-5 connections within the housing are
secured at the factory and do not need to be
adjusted. If it seems necessary to examine the
interior CAT-5 connections, contact Russound
Tech Support for instructions.
Female RJ45 Connection
At the back of the UNO-TS2D body is the female
RJ45 connector. This is hidden behind a strain
relief plate. The plate must be removed to con-
nect the CAT-5 cable with RJ45 connector and
replaced to hold the cable in place.
To remove the strain relief, use a screwdriver to
remove the screws.
Connect the CAT-5 cable with RJ45 connector
into the female RJ45 connector.
Bottom of UNO-TS2D showing strain
relief in place
INSTALLER GUIDE
UNO-TS2D RJ45 Connections
Replace the strain relief over the connected
cable, making sure the cable is not pinched.
Replace the screws on the strain relief.
To connect the UNO-TS2D to the
CAV6.6/CAM6.6 system, insert the free end of
the CAT-5 patch cable to an RJ45 wall plate
located near the touchscreen location.
Bottom of UNO-TS2D showing strain
relief removed and RJ45 connection
exposed
19