Related Manuals for elco HBR 20-25
Summary of Contents for elco HBR 20-25
- Page 1 NEW SERIES HIGH EFFICIENCY MOTORS ECM HBR IP66 / IP67 state of art technology for state of art performance...
- Page 2 ECM HBR motors are high efficiency drop-in replacements of the traditional shaded-pole ones Can use all the same accessories such as brackets, fans, DROP-IN rings and guards, with no-extra work and cost to the full REPLACEMENT benefit of fast and convenience.
- Page 3 MOTORS ECM HBR motors presents efficiency rates up to 72%. AND FAN FOR When used to move cold air at evaporators, ECM HBR motor is able to reduce the load of the compressor and REFRIGERATION thus its operating time, allowing further energy savings.
- Page 4 HBR motors can be universally applied,but are particularly suited to the refrigeration and ventilation industry, especially refrigerated GENERAL display cases, freezers, drink dispensers and SPECIFICATIONS small condensers. The motor is available in two sizes in relation to the power request and the fans mounted, from 154 mm to 254 mm, in Aluminium or plastic, with different pitches.
- Page 5 Diameter (mm) COMPATIBILITY TABLE WITH ELCO BLADES ° ° ° ° HBR 12-10 HBR 20-25 °...
- Page 6 HBR 12- HBR 20- DIMENSIONS A [mm] B [mm]...
- Page 7 Following mounting instruction to safely install the motor and prevent undesired vibrations MOUNTING INSTRUCTIONS Rubber Washers for HBR 12-10 Aluminium blades only HBR 20-25...
-
Page 8: Safety Information
Adhering to the operating instructions is a prerequisite for faultfree operating and fulfillment if any right to claim under warranty. Read the operating instructions before you start working with the unit. No paying attention to these warnings and instructions may lead to malfunctions and failures or OPERATING may seriously endanger human life. - Page 9 The fans are only to be operated within the ranges specified on the motor name-plate or in the technical specification released by Technical Dept. Do not make any modification, additions or conversation to the device without the approval from Regal Beloit Italy. OPERATING The unit complies with the applicable standard and regulation and meets the INSTRUCTIONS...
- Page 10 Connection and Start up Check the device for transport damage, the motor must not be installed if any damage is evidenced. Install the fan motor in accordance to your application OPERATING Use only cables that meet the specidic installation requirements for INSTRUCTIONS voltage, current, insulation material, load, etc.
-
Page 11: Technical Data
TECHNICAL DATA OPERATING Power voltage: 230 V - single phase Frequency: 50/60 Hz INSTRUCTIONS No load current: 0,025 A Speed: single Operating temperature: -30°C + 60°C Application: CR ( Commercial Refrigeration ) Insulation class: B Protection degree: IP66 / IP67 Operating mode: S1, intermittent is permitted EMC immunity &... - Page 12 Made in China by Regal Beloit Italy www.elco-spa.com info@elco-spa.com...
Need help?
Do you have a question about the HBR 20-25 and is the answer not in the manual?
Questions and answers