Memorex MI2290 - Portable Speakers With Digital Player Dock User Manual page 5

POWER SOURCES (CONTINUED)
BATTERY INSTALLATION
One CR2025 battery is used to save
the time and four (4) "AA" size batteries
can also be used to power this unit as
follows:
1. Open the Battery Compartment door
by pressing in on the tab and then
lifting it off.
2. Insert four "AA" batteries into the
Battery Compartment as shown. Be
sure to observe the polarity markings
which are engraved inside the battery
compartment. Alkaline batteries are recommended for the longest
playing time.
3. Open the CR2025 Battery Compartment door by pressing in on the
tab and then lifting it off.
4. Insert the CR2025 battery, paying attention to the polarity diagram in
the compartment (positive side up).
5. After inserting the CR2025 battery, replace the main Battery
Compartment door.
NOTE: The AC adapter must be disconnected from the DC IN jack
(located on the side of the stand) in order for the unit to operate on battery
power.
Follow these precautions when using batteries in this device:
1. Warning–Danger of explosion if battery is incorrectly replaced. Replace only
with the same or equivalent type.
2. Use only the size and type of batteries specified.
3. Be sure to follow the correct polarity when installing the batteries as indicated
in the Battery Compartment. A reversed battery may cause damage to
the device.
4. Do not mix different types of batteries together (e.g. Alkaline, Rechargeable
and Carbon-zinc) or old batteries with fresh ones.
5. If the device is not to be used for a long period of time, remove the batteries
to prevent damage or injury from possible battery leakage.
6. Do not try to recharge a battery not intended to be recharged; it can overheat
and rupture. (Follow battery manufacturer's directions.)
BATTERY PRECAUTIONS
5
CR2025