Outdoor Leisure Heat-N-Glo TD120A Owner's Manual page 6

ASSEMbLy
Continued
5. Install tank straps to base as (see Figure 5).
6. Install tank restraint to tank and fasten
restraint straps around legs as shown in
Figure 6.
7. Install the tank cover (see Figure 7).
8. Assemble reflector with small wing nuts
and bolts as shown in Figure 8.
9. Install reflector over post on top of burner
assembly. Install reflector cap over post.
Attach reflector and reflector cap using
large wing nuts (see Figure 9).
Figure 5 - Attaching Tank Straps to Base
Figure 6 - Tank Restraint Straps
6
Min. 2" from
Tank to Ground
www.desatech.com
Figure 7 - Tank Cover
Figure 8 - Reflector Assembly
Figure 9 - Attaching Reflector and
Reflector Cap to Burner Assembly
Wing Nuts
and Bolts
Bolts on
Top of
Burner
Assembly
Reflector
Cap
Wing
Nut
122139-01A