ROSE DISPLAYS FLOOR WINDO Instruction Sheet

Floor Windo

Parts

"Your Poster"

Assembly Instructions

Note:

• Use on dust-free surface only.
• Use in dry conditions only.
• Clean using any non-scratching detergent.

Step 1

Place poster into rubber rim, keeping rough side
of window on top. Fig. 1

Step 2

Start by bending all corners of the window into
the rubber rim. Keep Floor Windo

Step 3

Keep both thumbs on window. Bend rubber rim
down to flex rim over window. Fig. 3

Step 4

Make sure all sides are closed securely. Fig. 4

Step 5

If using on carpet, add Velcro Strips provided
to opposite ends of short sides to hold Floor
Windo ® more securely. Fig. 5
Floor Windo is a registered trademark of Floor Windo International.
Incept-10.25.00
®
Instruction Sheet
Rubber Rim
Rubber Rim
Clear window
"Your Poster"
Clear Window
® flat. Fig. 2
Velcro Strips
Clear Window
"Your Poster"
Rubber Rim
Figure 1
Flex to pop
Rim over
Window
Figure 3
Figure 5
Tel# 1- 800 631-9707 Fax# 1-800-560-2890
Adhesive
Corners
in first
Figure 2
Figure 4
35 Congress Street, Salem, MA 01970
e-mail:signware@rosedisplays.com