Related Manuals for SOLARJACK SDS - REV 4-92
Summary of Contents for SOLARJACK SDS - REV 4-92
- Page 1 SDS SERIES DC SUBMERISIBLE PUMPS REBUILD MANUAL Kyocera Solar, Inc. / SOLARJACK, 7812 E. Acoma Drive, Scottsdale, AZ 85260 Telephone (800) 223-9580 FAX (480) 483-6431 E-mail info@kyocerasolar.com www.kyocerasolar.com...
- Page 2 SDS PUMP REBUILD INSTRUCTIONS Rev.4/92 Remove cable guard screws (Item 1). Remove 1/8” pipe plug (Old Style) or 3/8” NC set screw (New Style) (Item 5) using a 3/16" hex wrench. WARNING: PUMP HOUSING MAY BE UNDER HIGH PRESURE. USE EXTREME CAUTION IN REMOVING END CAP PLUGS AND END CAP SCREWS.
- Page 3 SDS PUMP REBUILD INSTRUCTIONS ASSEMBLY Set the brass pistons (Items 18) flat side down on the pump assembly plate, positioning the two holes over the locating studs. Place the diaphragm (Item-17), with the offsets up, over the pistons locating the piston shafts through the two holes. On an SDS-D-128 use only the white santoprene diaphragm.
- Page 4 With the motor assembly still on the board, gently lift the diaphragm up on each end and insert one stainless washer (Item 6) in each motor adapter hole. Insert the two 10-22 X 2” motor adapter screws (Item 4) into the motor adapter holes.
- Page 5 Connect the motor leads to the electrical studs on the inside of the end cap. (Make sure the positive red wire lead connects to the red wire side, (yellow on two-wire pumps). Before seating end cap in housing, be sure that the terminals on the wires are tight on the end cap electrical studs.
- Page 6 12/06/99...
- Page 7 12/06/99...
- Page 8 12/06/99...
- Page 9 12/06/99...
- Page 10 12/06/99...
Need help?
Do you have a question about the SDS - REV 4-92 and is the answer not in the manual?
Questions and answers