Advertisement
Link discoverable mode
Rapid blinking LED
If the ZiiSound D5x LINK LED is still Rapidly Blinking, Press the LINK Touchpad / Button once to
E
stop or wait for it to timeout. Link establishment complete. Ready to Stream music.
2.2
Adding one or more ZiiSound D5x and DSx wireless subwoofer
A
Note: It is neccessary to clear the memory of linked speakers (all D5x(s) and DSx) should you
require to configure a new setup. (For example, adding another D5x or DSx)
Proceed to Step (b) if your D5x or DSx have not been linked with other speaker before.
If your D5x or DSx have been linked before, follow the instruction below to clear link system
memory to reconfigure a new speaker setup.
For the D5x(s)
Ensure the speaker is in standby mode. Press and hold the Power ON/ Standby button located at
the rear of the speaker until LINK and CONNECT LED blinks 2 times and goes off. The D5x Link
memory has been cleared.
For the DSx
Press and hold the LINK Button located at the rear of the subwoofer for 10 seconds until the Link
LED blinks 2 times and goes off. The DSx Link memory has been cleared.
to form a 2.1 or 3.1 speaker system
Linked mode with Wireless Subwoofer
LED Steady
13
Advertisement
