Advertisement
Quick Links
Advertisement
Related Manuals for Deli 3898
Summary of Contents for Deli 3898
- Page 1 G230LR-015(3898) G330LR-016(3899) G230LR-017(33022) G330LR-018(33023)
- Page 5 进膜 进膜 退膜 退膜 进/退膜开关 电源线 护卡膜进膜口 工作指示灯 冷裱 关 热裱 电源/功能开关 电源指示灯...
- Page 6 塑封操作说明 开机 热裱 退膜 冷裱 关机 在热裱状态...
- Page 8 机器温度过低或护卡膜厚 机器再加热2-3分钟后过膜； 度超出最大范围 更换护卡膜（厚度在要求的范围内） 开机时间过久，导致温度 偏高 护卡膜厚度超出规定范围 工作 绿灯已损坏 此时须联系售后服务中心或专业电工解决 机器内加热装置已烧坏 此时须联系售后服务中心或专业电工解决...
- Page 10 result cause...
- Page 11 in a tilted position The size of originals swaller than film 抰 originals can insert working Cold ON/OFF Switch...
- Page 12 Connect the power plug Turn on Open the back guide plate which is also the way to power on(the power switch hidden inside turns on automatically). If hot plastic cement is needed, adopt hot laminating film(50-125mic). Turn the temperature adjusting knob to the position of hot laminating,the power indicator will on in red laminating After about 7mins ’...
- Page 14 Machine temperate is too lo Laminator should be warmed up for 2-3mins or the thickness of the laminating more then laminating, again changing film is out of the maximum rated the film thickness to the right film(consistent film thickness. with the rated film thickness.) Machine temperate is too high , Should test with wasted film or paper first , caused by long time of warm up.
Need help?
Do you have a question about the 3898 and is the answer not in the manual?
Questions and answers