Table of Contents
Advertisement
Quick Links
M30
shown with
optional hose
and reel
011320
Manufacturers of Quality
Sewer & Drain Cleaning
Equipment since 1957
User Guide for
M20T, M20 or M30 Jetters
www.MyTana.com
746 Selby Ave • St. Paul MN, 55104
fax: 651.222.1739
M20T
1.800.328.8170
Factory Direct Customer Service
M –F 7am – 5pm CST
Competent • Polite • Clear
M20
shown with
optional hose
and reel
Advertisement
Table of Contents
Related Manuals for MyTana M30
Summary of Contents for MyTana M30
- Page 1 User Guide for M20T, M20 or M30 Jetters shown with optional hose and reel shown with optional hose and reel M20T 011320 www.MyTana.com 1.800.328.8170 Manufacturers of Quality Sewer & Drain Cleaning 746 Selby Ave • St. Paul MN, 55104 Factory Direct Customer Service fax: 651.222.1739...
-
Page 2: Important Notice
PG 2 MYTANA M20T / M20 / M30 Jetter USER MANUAL -IMPORTANT NOTICE- FOR YOUR SAFETY, AND TO ENABLE MAXIMUM USE AND EFFECTIVENESS OF YOUR EQUIPMENT, READ (AND UNDERSTAND) THIS INSTRUCTION MANUAL ENTIRELY BEFORE USING YOUR HIGH-PRESSURE WATER JETTING UNIT! - Page 3 PG 3 MYTANA M20T / M20 / M30 Jetter USER MANUAL Safety First! Instructions and Precautions Pumps Remove “shipping” plug on top side of Electric machines pumps and replace with vented plug. This is very important for the proper operation of the pumps.
-
Page 4: Model Details
General • General maintenance • Sharp turns, traps Applications • Ice, thick grease and/or sludge • Thorough cleaning of surface MyTana nozzles are precision machined hardened stainless steel, Rated for use up to 4000 psi... -
Page 5: Additional Components
PG 5 MYTANA M20T / M20 / M30 Jetter USER MANUAL Pumps Pressure Regulator/Unloader The regulator/unloader both regulates the pressure and Periodically change oil in pumps. relieves pressure on the pump while in bypass. The regulator knob is located at the pump. It allows you to adjust pressure •... -
Page 6: Pre-Operation Check List
PG 6 MYTANA M20T / M20 / M30 Jetter USER MANUAL Pre Operation Checklist • Check for adequate • Check ground fault • Select nozzle and make • Check hose reel and all water supply. Use no interrupter on electric... -
Page 7: Shutting Down
2. Reduce pressure gradually with pressure regulator by buffering sharp edges with tape, cardboard, etc., to knob until pressure gauge is at zero. maximize its useful life. MyTana has a TigerTail that helps 3. Stop the jetter motor/engine protect your hose. See MyTana.com for details. -
Page 8: Troubleshooting
PG 8 MYTANA M20T / M20 / M30 Jetter USER MANUAL Troubleshooting Problem Probable Cause Solution Worn nozzle Replace nozzle Oversized nozzle Attache correct nozzle Pulling air at inlet line Disassemble, reseal and reassemble Low Water Pressure Inlet strainer clogged...
Need help?
Do you have a question about the M30 and is the answer not in the manual?
Questions and answers