Table of Contents
Advertisement
Quick Links
Advertisement
Table of Contents
Related Manuals for SBV 52142
Summary of Contents for SBV 52142
- Page 1 23154 Reference 52295: 3/8" Drive Multi Angle Digital Torque adapter 4 to 203 Nm Reference 52142: 1/2" Drive Multi Angle Digital Torque adapter 4 to 203 Nm Read this material before using this product. WARNING Failure to do so can result in serious injury.
- Page 2 INTRODUCTION This instruction manual is intended for your benefit. Please read and follow the safety, installation, maintenance and troubleshooting steps described within to ensure your safety and satisfaction. The contents of this instruction manual are based upon the latest product information available at the time of publication.
-
Page 3: Important Safeguards
IMPORTANT SAFEGUARDS WARNING - TO AVOID DAMAGING DIGITAL TORQUE ADAPTER • Never operate digital torque adapter when powered OFF. Always power adapter ON prior to applying torque. • Never use this digital torque adapter to loosen fasteners as damage may occur. •... -
Page 4: Product Features
Main keyboard Calibration adapter Extension bar The SBV Digital Torque Adapter displays fastener torque specification settings, torque readings and peak hold measurements. • Digital torque readout. • Selectable for five torque units of measure: lb-ft, lb-in, kg-cm, kg-m and N-m. -
Page 5: Lcd Display Indicators
LCD DISPLAY INDICATORS Low battery icon Peak Hold Preset target torque Auto/Manual Torque value Trace Unit of Percentage of Preset number measure preset torque LOW BATTERY VOLTAGE INDICATION When the battery voltage drops below 2.4 volts, When battery voltage drops below 2.6 the low battery warning icon will begin to flash, volts, a low battery warning icon will indicating that immediate battery replacement is... -
Page 6: Selecting Units Of Measure
SELECTING UNITS OF MEASURE 1. With the unit on, press the (Digit shift) key to display the “normal mode” screen. 2. Press the (Digit shift) key to the activate the “set torque value” screen (far right digit flashes). 3. Press the the (Units) key to toggle the Units of measure indicator until the desired unit of mea- sure is displayed. - Page 7 PEAK HOLD MODE OPERATION In Peak hold mode, the digital display shows the maximum torque applied, which can be helpful for verifying that the correct torque was applied when the digital display is not visible during use. This mode is also handy when using the adapter to calibrate a torque wrench. AUTO MODE: Continue applying torque Percent of Target torque...
-
Page 8: Tracking Mode Operation
TRACKING MODE OPERATION In Tracking mode, the display will register torque as it is applied in real-time. This allows you to observe the digital display while applying torque to a fastener. Watching the torque value increase can assist you in applying torque evenly and safely, especially as you approach your target torque setting. -
Page 9: Battery Installation And Replacement
CHANGING ORIENTATION OF DISPLAY Press and hold button for 2 seconds to toggle the orientation of the display readout. Press POWERING OFF DIGITAL TORQUE ADAPTER Press and hold Mode button for 2 seconds to turn unit off. NOTE: This tool will automatically enter sleep mode after 3 minutes of inactivity. BATTERY INSTALLATION AND REPLACEMENT 1. - Page 10 CALIBRATING A TORQUE WRENCH USING DIGITAL ADAPTER 1. Set your torque wrench to a value of approxi- mately 25% of its maximum capacity. For example, if your torque wrench has a maximum capacity of 150 lb-ft, set it to 40 lb-ft. 2.
Need help?
Do you have a question about the 52142 and is the answer not in the manual?
Questions and answers