Sherwood PM-9805 Operating Instructions Manual
  1. Manuals
  2. Brands
  3. Sherwood Manuals
  4. Turntable
  5. PM-9805
  6. Operating instructions manual

Sherwood PM-9805 Operating Instructions Manual

Hide thumbs

Advertisement

Table of Contents

Advertisement

Table of Contents
loading

Related Manuals for Sherwood PM-9805

Summary of Contents for Sherwood PM-9805

  • Page 2 O P E R A T I N G I N S T R U C T I O N S PM-9805 TURN TABLE T U R N TA B L E...
  • Page 3 PRECAUTIONS Thank you for purchasing this fine product – STEREO TURNTABLE. Taking time to read these operation instructions carefully. Read this manual carefully before using the unit and be sure to store the manual in a safe place for future reference. 1.

  • Page 4: Name Of The Parts

    NAME OF THE PARTS 1. 45-rpm Adaptor 10. Pitch Control Slider (+/– 10%) 2. Slip Mat 11. Tonearm 3. Center Spindle 12. Cueing Lever 4. Strobe Dots 13. Arm Rest 5. Power Switch / Strobe 14. Anti-skate Knob 6. Start/Stop Button 15.
  • Page 5 CONTENTS ASSEMBLY 1. Please unpack set as confirm following parts. 6. Installation of cartridge: • Turntable platter When installing a cartridge, refer to the operating • Slip Mat instructions for that particular cartridge. • Dust Cover During installatiion, attach the stylus protector to •...

  • Page 6: Adjusting The Tonearm

    ADJUSTING THE TONEARM Level Balance Adjustment Tracking Force Adjustment 1. Set the ANTI-SKATE knob to “0”. Turning the counterweight, set the correct tracking force opposite the index line on the counterweight 2. Release the arm clamp and move the tonearm to shaft.

  • Page 7: Controls And Operation

    CONTROLS AND OPERATION 1. Turn the (On/Off Switch) clockwise to turn on the 7. Move the tonearm over he desired groove. power, the speed indicator and the strobe- illuminator, which is located beneath the On/Off 8. Set the cueing lever to the down position, the switch, will light up.
  • Page 8 CONNECTIONS CONNECTIONS This set’s phono cables and ground lead are This should be firmly connected to the ground attached to the rear panel of the turntable. The phono terminal on the mixer. cable with the white plug is for the left channel and The way in which the phono cables are attached will the one with the red plug is for the right channel.
  • Page 9 CONNECTIONS STYLUS REPLACEMENT The life expectancy of the stylus tip is 500 hours. For the sake of maximum sound quality reproduction, we recommend replacement within the minimum time limit. 1. The stylus tip is replaced by grasping the stylus holder and pulling it away from the body of the cartridge.

  • Page 10: General Specification

    GENERAL SPECIFICATION 1. APPLICATION : This spectftcation applies to the belt drive turntable unit PM-9805 2. STANDARD TEST CONDITION : Ambient Temperrature 23 A 2LC Relative Humidity 65% A 5% NOTE : Measurements can be carried out betwee 5LC and 45% to 85% relative humidity.

  • Page 11: Troubleshooting

    TROUBLE SHOOTING Sometimes, an operational fault can be mistaken for a malfunction or failure. Check the following points and see if you can find the symptoms of the trouble below before you get in touch with the serviceman. If you cannot locate the symptoms, contact your nearest dealer.

Table of Contents