PianoDisc ProScan Installation Procedure With Troubleshooting Manual

ProRecord and ProScan Installation Procedure
Installation Procedure
1. Disassemble the piano
o Remove the action from the piano.
o Remove the stack and keys from the keyframe.
o Place the key upside down on a bench supported by two long pieces of wood to level the bottom
of the keys.
2. Placing reflective tape on keys 1 and 88
NOTE: The following procedure is the same whether a grand or vertical.
o Locate the reflective tape and paper jig in the kit.
o Starting with key 1 and 88, place the template on the front/bottom of the key and attach the
reflective tape. Do this on both keys.(See Ill. 1)
Note: Because keys 1 & 88 are wider than other white keys, the reflective tape is place on one side
of the key to line up with the optical sensor. (See Ill. 1 and the template)
for Grand Pianos
With Troubleshooting Guide
:
Illustration 1 – Locating reflective tape on keys 1 and 88
March 13, 2014