Table of Contents
Advertisement
INSTALLING
TO WALL
Continued
INSTALLING HEATER TO
WALL
Marking Screw Locations
1. Determine where you will locate heater.
WARNING: Maintain minimum
clearances shown in Figure 5. If
you can, provide greater clear-
ances from floor and joining wall.
2. Mark two mounting screw locations on
wall (see Figure 5).
7 3/4"
10 7/8"
Minimum To
Maintain 6"
Clearance
From Wall
Mounting
Screw
Locations
FLOOR
Figure 5 - Mounting Screw Locations
Installing Two Mounting Screws
Wall anchors and mounting screws
Note:
are in hardware package. The hardware pack-
age is provided with heater.
Attaching to Wall Stud Method
For attaching mounting screw to wall stud
1. Drill hole at marked location using 9/
64" drill bit.
2. Insert mounting screw into wall stud.
3.
Tighten screw until 1/16" space
(thickness of penny) is between
screwhead and wall.
103549
Attaching to Wall Anchor Method
Follow instructions below to attach mount-
ing screws to hollow walls (wall areas be-
tween studs) or solid walls (concrete or
masonry).
1.
Drill holes at marked locations using
5/16" drill bit. For solid walls (concrete
or masonry), drill at least 1 1/4" deep.
2.
Fold wall anchor (see Figure 6).
3.
Insert wall anchor (wings first) into
hole. Tap anchor flush to wall.
Figure 6 - Folding Anchor
4.
For thin walls (1/2" or less), insert red
key into wall anchor. Push red key to
"pop" open anchor wings (see Figure
7).
IMPORTANT:
For thick walls (over 1/2" thick) or solid
walls, do not pop open wings.
20 1/4"
Minimum To
Thin Walls
Maintain 3"
(1/4" to 1/2" thick)
Clearance
From Floor
Figure 7 - Popping Open Anchor Wings
For Thin Walls
5.
Tighten two screws until 1/16" space
(thickness of penny) is between
screwheads and wall (see Figure 8).
1/16" Space
Figure 8 - Tightening Anchors
OWNER'S MANUAL
Placing Heater on Mounting
Screws
1.
2.
Figure 9 - Location Of Keyhole Slots On
Back Panel Of Heater
Removing Front Panel of Heater
1.
2.
Do not hammer key!
3.
Figure 10 - Removing Front Panel Of
Heater
Thin or
Thick Wall
Installing Bottom Mounting
(thick wall
Screw
shown)
1.
Solid
2.
Wall
3.
7
Locate two keyhole slots on back panel
of heater (see Figure 9).
Place large openings of slots over
screwheads. Slide heater down until
screws are in small portion of slots.
Keyhole
Slots
Remove two screws near bottom
corners of front panel.
Lift straight up on grill guard until it
stops. Grill guard will slide up about
1/4".
Pull bottom of front panel forward, then
down.
Locate bottom mounting hole. This
hole is near bottom on back panel of
heater (see Figure 11, page 8).
Mark screw location on wall.
Remove heater from wall.
Continued
Advertisement
Table of Contents
