Air Lift Performance AutoPilot V2 Installation Manual

Air management kit

Advertisement

Quick Links

Need Help?
Contact our customer service department by calling
(800) 248-0892, Monday through Friday, 8 a.m. to
7 p.m. Eastern Time. For calls from outside the USA
or Canada, our local number is (517) 322-2144.
Thank you for purchasing Air Lift Performance products!
Air Lift Company • 2727 Snow Road • Lansing, MI 48917 or PO Box 80167 • Lansing, MI 48908-0167
Toll Free (800) 248-0892 • Local (517) 322-2144 • Fax (517) 322-0240 • www.airliftperformance.com
Printed in
the USA
Air Lift
PERFORMANCE
AutoPilot V2
Kits 27669
and 27671
INSTALLATION GUIDE
For maximum effectiveness and safety,
please read these instructions completely
before proceeding with installation.
Failure to read these instructions can result in an
incorrect installation.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the AutoPilot V2 and is the answer not in the manual?

Questions and answers

Summary of Contents for Air Lift Performance AutoPilot V2

  • Page 1 7 p.m. Eastern Time. For calls from outside the USA or Canada, our local number is (517) 322-2144. INSTALLATION GUIDE Thank you for purchasing Air Lift Performance products! For maximum effectiveness and safety, please read these instructions completely Air Lift Company • 2727 Snow Road • Lansing, MI 48917 or PO Box 80167 • Lansing, MI 48908-0167 before proceeding with installation.
  • Page 2: Replacement Information

    AutoPilot V2 AutoPilot V2 Replacement Information If you need replacement parts, contact the local dealer or call Air Lift customer service at (800) 248-0892. Most parts are immediately available and can be shipped the same day. TABLE OF CONTENTS Contact Air Lift Company customer service at (800) 248-0892 first if: •...
  • Page 3: Warranty And Returns Policy

    AutoPilot V2 AutoPilot V2 Warranty and Returns Policy Installing the AutoPilot V2 Kit Air Lift Company warrants its performance products for one year to the original purchaser INSTALL COMPONENTS against manufacturing defects one year from the date of purchase when used on cars and trucks as specified under normal operating conditions.
  • Page 4: Troubleshooting Guide

    AutoPilot V2 AutoPilot V2 Troubleshooting Guide INSTALLING HARNESS DISCONNECT BATTERY WHILE INSTALLING SYSTEM. CAUSE SOLUTION PROBLEM There is a blown fuse, bad ground, or Replace the fuse, check the Compressor / Manifold Connections (see fig. 10) Compressor doesn’t run. ground wire, or check the poor electrical connections.
  • Page 5: Electrical Schematic

    AutoPilot V2 AutoPilot V2 Electrical Schematic MANUAL Mode MANUAL mode allows the user to fill or exhaust each spring. The display will show arrows above and below the pressures to indicate the manual control mode. The arrow will be solid when the spring is filling / exhausting, and just the outline when not active.
  • Page 6: Setup And Calibration

    AutoPilot V2 AutoPilot V2 Setup and Calibration EDIT EDIT AutoPilot V2 is an advanced Pressure-Based Air Suspension Control System, using State- of-the-Art software algorithms to “calibrate” or map the Control System to your vehicle. Once PRESET 6 PRESET 7 the system is calibrated, the algorithm predicts required Valve Open Time to move the air fig.
  • Page 7: Program Presets

    AutoPilot V2 AutoPilot V2 Program Presets 7. Press Button 4 to enter PRESET MAINTAIN (fig. 6). Press Button 8 to turn ON or OFF. When ON, this function actively monitors Air Spring Pressure and will fill to maintain active Preset Pressure. NOTE: Preset 1 should always be entered as the desired “Ride”...
  • Page 8 AutoPilot V2 AutoPilot V2 fig. 10 MN-754 MN-754...

Table of Contents