Table of Contents
Advertisement
INSTALLATION
Continued
INSTALLING LOGS ON
MODEL CCL3930NT(A)
WARNING: Failure to position
the parts in accordance with these
diagrams or failure to use only
parts specifically approved with
this heater may result in property
damage or personal injury.
CAUTION: After installation and
periodically thereafter, check to en-
sure that no flame comes in contact
with any log. With the heater set to
High, check to see if flames contact
any log. If so, reposition logs ac-
cording to the log installation in-
structions in this manual. Flames
contacting logs will create soot.
Each log is marked with a number. These
numbers will help you identify the log when
installing. It is very important to install these
logs exactly as instructed. Do not modify
logs. Only use logs supplied with heater.
1. Place the front log (#1) on the grate fin-
gers. Make sure the front log rest firmly
between the grate fingers and the grate
base (see Figure 23).
2. Place the base of the middle log (#2) in
the U-shaped slots of the grate base. The
cutout on the right of the middle log
should fit over the burner (see Figure 24).
Make sure the front of the middle log is
resting on the tabs of the grate base.
3. Locate pegs on the bottom of back log (#3).
Slide these pegs into the holes in the grate
base behind the burner (see Figure 25).
Front Log (#1)
Grate
Fingers
Figure 23 - Installing Front Log (#1)
104385
4. Locate pegs on the bottom of crossover
log (#4). Slide these pegs into the holes
located in middle log (#2) and back log
(#3). See Figure 26 for placement.
5. Locate pegs on the bottom of crossover
log (#5). Slide these pegs into the holes
located in crossover log (#4) and front
log (#1). See Figure 27.
Figure 24 - Installing Middle Log (#2)
Figure 25 - Installing Back Log (#3)
Log #2
Grate Base
Figure 26 - Installing Crossover Log (#4)
OWNER'S MANUAL
Middle Log (#2)
Burner
U-Shaped
Tab
Slot
Pegs
Hole in
Grate Base
Burner
Pegs
Log #3
15
6. Locate pegs on the bottom of crossover
log (#6). Slide these pegs into the holes
located in back log (#3) and front log
(#1). See Figure 28.
7. Locate pegs on the bottom of crossover
log (#7). Slide these pegs into the holes
located in crossover log (#6) and front
log (#1). See Figure 29.
8. Add lava rock around base of heater. Do
not place any lava rock on logs or burner.
Crossover Log (#4)
Front Log (#1)
Figure 27 - Installing Crossover Log (#5)
Front Log (#1)
Figure 28 - Installing Crossover Log (#6)
Pegs
Front Log (#1)
Figure 29 - Installing Crossover Log (#7)
Pegs
Log #2
Crossover
Log (#6)
Advertisement
Table of Contents
