Table of Contents
Advertisement
Quick Links
PC-2, PC-3 and PC-4
52026771
INSTRUCTION MANUAL
Pressing Chains
Read and understand all of the instructions and
safety information in this manual before operating
or servicing this tool.
NIBCO Inc. – World Headquarters
1516 Middlebury Street
Elkhart, IN 46516
USA
Technical Services
Phone: 1-888-446-4226
Fax: 1-888-336-4226
© 2006 NIBCO Inc.
12/06
Advertisement
Table of Contents
Related Manuals for Nibco PC-4
Summarization of Contents
Product Introduction and Overview
Purpose of this Manual
Details the manual's objective and target audience for the pressing chains.
Product Description
Describes the PC-2, PC-3, and PC-4 Pressing Chains and their intended use.
Warranty Information
Provides information on warranty coverage for NIBCO pressing tools.
Important Safety Information
Safety Alert Symbol and Definitions
Explains the safety alert symbol, signal words (DANGER, WARNING, CAUTION), and their meanings.
General Operational Safety Warnings
Covers essential warnings for operating the pressing tool safely, including eye protection and pinch points.
Specific Hazard Warnings
Details hazards like electric shock, skin injection from oil, and risks associated with solvents.
Usage and Maintenance Precautions
Outlines precautions for tool inspection, usage limitations, environmental conditions, and battery safety.
Operation Guide
Pre-Operation Checks
Ensures the tool and pressing chains are in good condition before starting operation.
Chain Installation
Step-by-step instructions for selecting, inspecting, and installing the correct pressing chain.
Pressing Procedure
Details the sequence for pressing fittings using the tool, including trigger operation and cycle completion.
Post-Pressing Chain Removal
Instructions on how to disengage and remove the pressing chain after a completed press cycle.
Maintenance and Specifications
Daily and Monthly Maintenance
Covers cleaning, inspection, and lubrication procedures for the pressing chains.
Annual Inspection
Recommends returning the chain to a service center for inspection after 10,000 presses.
Technical Specifications
Lists mass/weight for PC-2, PC-3, PC-4 chains and required thrust force.
Need help?
Do you have a question about the PC-4 and is the answer not in the manual?
Questions and answers