Operating Instructions - Chicago Electric 95912 Assembly And Operation Instructions Manual

REd/POsITIVE (+)
POWER CABLE
VEHICLE BATTERY
(NOT INCLudEd)
BLACk/NEgATIVE (--)
POWER CABLE
WARNINg! The remote control operates by radio frequency. The receiver
has a delay to avoid signal interference. When the winch is operating (either
IN or OuT), it will continue to run for 1 to 2 seconds after the remote button
is released.
1. Place the vehicle's transmission in
block the wheels from rolling, using suitable chocks (not included).
2. When using the Winch to move a load, place the vehicle transmission in neutral,
set the emergency brake, and chock all the wheels of the vehicle. The vehicle
engine should be running during the winch operation. If considerable winching is
performed with the vehicle's engine shut off, the vehicle battery may be too weak
to assist winching and to restart the engine.
WARNINg! This Winch is designed for outdoor use only. Do not operate the
3.
Winch in a closed area or in a poorly ventilated area. When running, the engine of
the vehicle produces carbon monoxide, a colorless, odorless, toxic gas that, when
inhaled, can cause serious personal injury or death.
4. Disengage the Freewheel Knob (1) of the Winch by turning the Knob to the
position. (see figure C, next page.)
NOTE:
5. The Hook Strap (24) may be temporarily attached to the Clevis Hook (22)
as an aid in pulling out the desired length of Wire Cable. (see figure C.)
for technical questions, please call 1-800-444-3353.
SKU 95912
(26)
(26)

OPERATINg INsTRuCTIONs

"NEuTRAL". Set the emergency brake, and
fIguRE B
"OuT"
REV 08d
Page 8