Advertisement
a protective hair covering to prevent long hair from becoming caught in moving parts. If wearing a
long-sleeve shirt, roll sleeves up above elbows.
4.
CHECK FOR DAMAGED PARTS. Before using this product, carefully check that it will
operate properly and perform its intended function. Check for damaged parts and any other
conditions that may affect the operation of this product. Replace or repair damaged or worn
parts immediately. When servicing, use only identical replacement parts. Only use accessories
intended for use with this product. Approved accessories are available from Harbor Freight Tools.
5.
MAINTENANCE: For your safety, service and maintenance should be performed regularly by a
qualified technician.
6.
USE THE RIGHT PRODUCT FOR THE RIGHT JOB. There are certain applications for which
this product was designed. Do not use small equipment, tools or attachments to do the work of
larger industrial equipment, tools or attachments. Do not use this product for a purpose for which
it was not intended.
7.
The warnings and cautions discussed in this instruction sheet cannot cover all possible conditions
and situations that may occur. It must be understood by the operator that common sense and
caution are factors which cannot be built into this product, but must be supplied by the operator.
1.
The Jaws are reversible to ensure proper grip on a wide range of jobs. Depending on the depth
of the pulling job, keep either the longer or shorter ends of the Jaws down to grip the underside
of the bearing/pulley.
2.
Hand tighten the Lead Screw through the bearing/pulley and onto the shaft from which the bear-
ing/pulley is to be removed. Once in position, wrench tighten the Lead Screw until the bearing/
pulley is completely free of the shaft.
INSPECTION, MAINTENANCE, AND CLEANING
1.
Before each use, inspect the general condition of the Gear Puller. Check misalignment, binding
of moving parts, broken parts, and any other condition that may affect its safe operation. If any
malfunction of the parts occur, discontinue using the Gear Puller immediately and have the
problem corrected before further use. Do not use damaged equipment.
2.
Keep the Gear Puller clean for better and safer product performance. To clean, use a mild
detergent or mild solvent. Then dry.
Note:
Replacement parts are not available for this item.
SKU 08832
OPERATING INSTRUCTIONS
For technical questions, please call 1-800-444-3353.
Page 2
Advertisement
