Advertisement
C.) Connect one Ammeter wire to the termi-
nal post where the hot lead was just
removed.
D.) Connect the other Ammeter lead to the
hot wire disconnected in Step C. Insulate
wire from any ground contact.
E.) Follow Steps F and G, above.
5.
In cars with the solenoid mounted directly on
the starter (such as Chrysler and most inde-
pendent models) refer to Figure 4 (below)
during the following steps:
To Hot Wire
Figure 4
A.) Follow Step A on previous page.
B.) Disconnect the smaller wire (red) from the
solenoid terminal where the heavy bat-
tery cable is terminated.
C.) Connect one Ammeter lead to the wire
just removed from the solenoid batter
terminal. Insulate the joint from any
ground contact.
D.) Connect the other Ammeter lead to the
solenoid battery terminal post.
E.) Follow Steps F and G, on previous page.
Water temperature gauge
1.
Locate suitable opening in engine block to
reach the cooling system water or locate the
presently installed water temperature sender.
2.
Inset bulb on end of tube into the hole and
screw fitting on tube into the hole until bulb is
held securely in place. See Figure 5, above.
SKU 65210
Starter
Battery
Mounted
Solenoid
Starter
For technical questions, please call 1-800-444-3353.
Water Jacket
To Lighting Circuit
Thermo Bulb
Special Adaptor
Figure 5
3.
The tube fitting should fit most cars. Use
adaptors (included) if they do not. If adap-
tors do not properly fit, check with vehicle
dealership parts and services center for cor-
rect adaptor.
Illuminating Instructions For all gauges
1.
To have Gauge Set lights operate off the
same switch as the dashboard light, splice
the wire from the lamp bulb socket into any
wire presently used for lighting instrument
panel. Tape to insulate.
WarnIng!
2.
Be sure that mounting panel
is electrically grounded to chassis of car to
ensure steady gauge indications and light
intensity.
3.
To connect Gauge Set to 6V system, remove
the 12V bulbs and replace with 6V bulbs (not
included.)
record serial number Here:
note: If product has no serial number, record
month and year of purchase instead.
note: No replacement parts are available.
Dash Panel
Gauge
Capillary Tubing
Page 4
Advertisement
