Advertisement
•
tHiS RAmp iS fOR uSe witH 4-wHeeled AtV'S Only. dO nOt uSe tHiS
RAmp tO unlOAd 2- OR 3-wHeeled VeHicleS.
•
dO nOt uSe tHiS RAmp tO unlOAd Any VeHicle tHAt weigHS mORe tHAn
1250 lB.
•
dO nOt uSe tHiS RAmp tO unlOAd Any VeHicle tHAt iS wideR tHAn tHe
RAmp.
•
dO nOt uSe tHiS RAmp tO unlOAd Any VeHicle tHAt iS cARRying geAR
On itS RAcKS.
•
dO nOt uSe tHiS RAmp if tHe tAilgAte On tHe VeHicle Being unlOAded
iS HigHeR tHAn HAlf tHe RAmp'S lengtH (34").
warning! All persons not involved in the unloading process must stand clear of the
loading Ramp and truck.
wARning! Riding An AtV wHile unlOAding iS
dAngeROuS And SHOuld nOt Be Attempted.
Have an assistant monitor the Ramp tongue for slippage on the tailgate.
1.
2.
Setup the ramp on the truck bed as explained under operation, page 4. Remove all tie
down straps and securing equipment from the ATV.
wARning! Be SuRe tHe 4-wHeeled AtV iS centeRed On RAmp.
3.
While staying off the ATV, start the engine, disengage the parking brake, put the transmis-
sion into reverse, and make sure the wheels are in a straight line with the ramp. While
holding the brake, position yourself in front of the ATV.
4.
Release the brake and push on the ATV to get it started down the ramp. Allow the ATV
to roll down naturally, do not attempt to steer it or apply the brakes. If it stops while on
the ramp, gently give it throttle to back it off the ramp.
1.
Clean the ramp after each use. Make sure any dirt, oil, grease, or debris are not on the
Ramp.
2.
Check the Ramp and Safety chains and Hooks (2) for cracks, signs of stress, bends,
or breakage. Do not use the Ramp if faults are discovered. Take the Ramp to a qualified
service technician if repairs are required.
SKU 46862 for technical questions, please call 1-800-444-3353.
AtV unloading
wARning!
maintenance
ReV 10/06
Page 6
Advertisement
