Table of Contents
Advertisement
Convection Heated Plate and Base
Dispensers Operating Manual
Plate or Base Heater:
SECTION 1: INTRODUCTION
Introduction ..............................................................................2
Information...............................................................................2
Set Up ..................................................................................2-3
Electrical ..................................................................................3
SECTION 4: OPERATING INSTRUCTION
Start Up ..................................................................................3
SECTION 5: PROGRAMMING
Programming ...........................................................................4
For Service Information call 1.888.673.4639
Please provide following information:
• Model number
• Serial number
• Part Description and number as shown in parts list
© 2011 DINEX | CARLISLE
•
4711 EAST HEFNER ROAD, OKLAHOMA CITY, OK 73131
DO NOT DISCARD
Model:
For Equipment with Serial
110613B and Newer.
SECTION 6: ALARMS
Alarms .....................................................................................5
Cleaning ..................................................................................5
Problem/Possible/Remedy Chart ............................................5
Chart ........................................................................................6
Base Dispenser Assembly Diagram ........................................7
Plate Dispenser Assembly Diagram ........................................8
Wiring Diagrams .................................................................9-11
WARRANTY ..........................................................................12
DXIDPC20120
DXIDPC30180
DXIDWB20900
DXIDWB30900
DXIDPWB20900
Manual No. Plate_Base_Heater_0411
•
WWW.DINEX.COM
Advertisement
Table of Contents
Related Manuals for Dinex DXIDPC30180
Summary of Contents for Dinex DXIDPC30180
-
Page 1: Table Of Contents
Please provide following information: • Model number • Serial number Manual No. Plate_Base_Heater_0411 • Part Description and number as shown in parts list © 2011 DINEX | CARLISLE • 4711 EAST HEFNER ROAD, OKLAHOMA CITY, OK 73131 • WWW.DINEX.COM DO NOT DISCARD... -
Page 2: Introduction
GENERAL INFORMATION Congratulations! You have just purchased one of the finest The Dinex Plate or Base Heater is designed specifically for use pieces of equipment on the market today. Before installing or with a wide variety of 9" stainless steel bases and plates. -
Page 3: Electrical
Convection Heated Plate and Base Dispenser | 3 6. To set the proper spring tension and dispensing level, ELECTRICAL place ten wax bases in the self-leveling dispenser on right side of unit (Figure 1). Add or remove springs by hooking or Refer to the General Information Section on page 2, your unhooking the bottom of the spring from the moving carriage local code or the National Electrical Code to be sure the unit is... -
Page 4: Programming
Convection Heated Plate and Base Dispenser | 4 Operation PROGRAMMING 1. Plug the unit into the electrical outlet. Operation: At power on the display will indicate “020” and the program version for a few seconds. The control will then start 2. -
Page 5: Alarms
Convection Heated Plate and Base Dispenser | 5 Casters ALARMS 1. Check casters for freedom of movement and proper brake operation. If either Temperature Sensor is “open” or not plugged in, the Audio Alert will sound, the corresponding heater output will be 2. -
Page 6: Section 9: Replacement Parts Chart
Convection Heated Plate and Base Dispenser | 6 REPLACEMENT PARTS IDPWB2/0900 Description Description Part Number Quantity Part Number Quantity DX186140372 208/240V MOTOR DX160953111 LID HINGE ASSY LEFT SIDE DX186160241 POWER SUPPLY BOARD DX160953112 LID HINGE ASSY RIGHT SIDE CONTROL - PLATE HEATER DX186160332 DX160953113 LID HINGE ASSY MIDDLE... -
Page 7: Section 10: Parts Chart Base Dispenser Assembly Diagram
Convection Heated Plate and Base Dispenser | 7 Base Dispenser Assembly Part Number Description Quantity DX186170087 DISPENSER BUSHING DX186170489 DISPENSER PULLEY DX184002015 DISPENSER SPRING Pulley bracket - DX165052092 Description Part Number Quantity DX160953128 BASE DISPENSER ASSEMBLY... -
Page 8: Plate Dispenser Assembly Diagram
Convection Heated Plate and Base Dispenser | 8 Plate Dispenser Assembly Part Number Description Quantity DX186170087 DISPENSER BUSHING DX186170489 DISPENSER PULLEY DX184002015 DISPENSER SPRING Parts Number Description Quantity DX160953120 PLATE DISPENSER ASSEMBLY... -
Page 9: Wiring Diagrams
Convection Heated Plate and Base Dispenser | 9... - Page 10 Convection Heated Plate and Base Dispenser | 10...
- Page 11 Convection Heated Plate and Base Dispenser | 11...
-
Page 12: Warranty
(v) the use of the Warranted Product in a manner or environment, accessories that are shipped with Warranted Products is covered by a or for any purpose, for which Dinex did not design or license it, or separate warranty statement, which is available at www.dinex.com. - Page 13 Convection Heated Plate and Base Dispenser | 13 NOTES:...
- Page 14 Manual No. Plate_Base_Heater_0411 © 2011 DINEX | CARLISLE • 4711 EAST HEFNER ROAD, OKLAHOMA CITY, OK 73131 • WWW.DINEX.COM...
Need help?
Do you have a question about the DXIDPC30180 and is the answer not in the manual?
Questions and answers