Bering DX606v Installation Instructions

INSTALLATION INSTRUCTIONS

Compatible Models: Optoma EP731/732/732H/737/738/739/H30

READ THIS BEFORE YOU START

Maximum weight limit is 20 pounds (9.1 kg).
Do not exceed this limit.
Always use caution and care when working with
heavy projectors.
DO NOT TAKE UNNECESSARY RISKS!
Once you have chosen a location for the mount,
determine the construction of the ceiling.
•
Solid wood surface: a beam, or a wood joist
inside the wallboard.
•
Wallboard: sheet
paneling.
•
Masonry: plaster, cement or brick.
It is recommended that the ceiling mount be
mounted to a ceiling beam or wood joist.

TOOLS REQUIRED

•
Hex wrench (included).
•
Phillips screwdriver
•
Drill with a 5/16" bit for the TC® anchors
__________________________________________________________________________
Model: CM-E73X
rock, plasterboard or
CAUTION: Use only the supplied TOGGLER®
TC® drywall/plasterboard anchors to support the
ceiling mount screws. Use them as anchors to
fasten the ceiling mount to sheet rock, plaster
board or paneling. Use the TOGGLER® Alligator®
anchor for solid wood or masonry. (See enclosed
TOGGLER® Anchoring Solutions brochure.)
Before installing the ceiling mount, make sure the
mounting location is sturdy enough to support the
projector. If you are not sure that your location will
hold the projector's weight, contact a professional
contractor for advice.
Recommend maximum extension; do not exceed
15 inches if the base join is angled.
•
Drill with a 1/4" bit for the AF6 Alligator® anchors.
•
Two crescent or 3/4" open-end wrenches.
T.M.