Smart Living Smart Solar 3702WR20 Manual

Solar String Lights
Introduction
Solar lights work by using electricity generated by the solar panel to charge internal batteries. These batteries are
then used to power the light. When switched on the lights automatically illuminate at night by using a sensor. The
duration of illumination will depend on the amount of sunlight and therefore charge received by the batteries.
Contents
Display switch
Light string
(Shape of cover may vary)
Position

solar panel to receive the maximum amount of sunlight.
Position
First Use
First unplug the display switch used for the "try me"
packaging (see NOTE to right). Although there may be some
charge left in the battery we recommend fully charging it
before first use. Leave the switch in the off position for 2
sunny days to ensure the battery is fully charged. Once fully
charged, switch to auto. The light will automatically illuminate
when it gets dark. You can cover the solar panel to test that
the light is operating.
Battery
Rechargeable batteries become less efficient with repeated
charge-discharge cycles and the battery capacity reduces. If you find
that the battery appears ot be less efficient or does not run for long we
suggest you first try to boost charge it. Switch off for 3 to 5 sunny days
to allow the maximum charge to the battery. If after this boost charge
your battery still does not perform to expectations you should replace it.
To change the battery, remove 4 screws and open the compartment as
shown, remove the existing batteries and replace with a new ones. Only
use 1.2V Ni-MH rechargeable batteries. Please ensure that the batteries
are disposed of according to local regulations.
Customer Service
For immediate answers visit our website www.smartlivinghg.com where you will find troubleshooting and
FAQs or contact us using the details below.
(For retail Try Me buttons only)
Solar panel

One year limited manufacturer's warranty.
customerservice@smartlivinghg.com
Mounting tube

Do not position the solar panel under a light as this
will prevent the light from switching on at night.
Off/Auto switch
www.smartlivinghg.com
Spike
Unplug display switch
NOTE: Only units in a retail box
with a Try Me button will need to
remove the display switch.
Disregard this step if your unit
was sold in a plain box without a
Try Me button.
To light string
Switch
