Remote Administration Usage Example - ESET FILE SECURITY - FOR LINUX BSD AND SOLARIS Installation Manual

Figure 6-6. ERA Console tabs.
For more information, please read the ESET Remote Administrator manual. This manual is located on our web site at the
following link:
http://www.eset.com/documentation
6.5.1

Remote Administration usage example

Before commencing any remote administration process ensure your system fulfills the three following prerequisites:
Running ERA Server
Running ERA Console
Enable RA Client in the ESETS daemon. Ensure that firewall settings do not block traffic to ERA Server or vice versa.
To setup the basics, specify the address of your ERA Server in the 'ra cl_server_a ddr' parameter first. If you are using a password
to access the ERA Console password, you must edit the value of the 'ra cl_pa ssword' parameter accordingly. Change the value of
the 'racl_interval' parameter to adjust the frequency of connections to ERA Server (in minutes).
You can either use the web interface (see also previous chapter) to apply the new configuration, or you can adjust these
parameters in the [g loba l] section of the ESETS configuration file as follows:
racl_server_addr = "yourServerAddress"
racl_server_port = 2222
racl_password = "yourPassword"
racl_interval = 1
NOTE: All applicable ESET Remote Administration Client variables are listed on the esets_da emon(8 ) man page.
The ESETS daemon configuration will be reloaded and RACL will connect to ERA Server. You will be able to see a newly
connected client in your ERA Console. Press the F5 button (or M enu > V iew > Refresh ) to manually refresh the list of connected
clients.
Figure 6-7. ERA Console.
By using ERA Console you can create a configuration task to ESETS daemon from ERA Console:
Right click the connected Client N a me
Navigate to N ew Ta sk > Config ura tion Ta sk > Crea te...
Expand Unix ESET Security tree
For an example of a configuration task by the DAC agent, see below:
18