Table of Contents

Advertisement

PILOT'S OPERATING HANDBOOK
1977
ssna
150
Commuter
CESSNA MODEL 150M

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 150M 1977 and is the answer not in the manual?

Questions and answers

Summarization of Contents

Section 1 General
Introduction
Provides basic data and general information about the aircraft.
Descriptive Data
Details engine, propeller, fuel, oil, and weights.
Airspeed Terminology and Symbols
Defines general airspeed terms and symbols for clarity.
Engine Power Terminology
Explains terms related to engine power and performance.
Weight and Balance Terminology
Defines terms related to aircraft weight and balance.
Section 2 Limitations
Introduction
Outlines operating limitations, instrument markings, and placards.
Airspeed Limitations
Details airspeed limitations and operational significance.
Airspeed Indicator Markings
Explains airspeed indicator markings and color codes.
Power Plant Limitations
Specifies limitations for the engine and propeller.
Weight Limits
Lists maximum takeoff, landing, and baggage weights.
Center of Gravity Limits
Defines the aircraft's center of gravity range.
Maneuver Limits
Outlines permitted maneuvers and their entry speeds.
Flight Load Factor Limits
Specifies load factors for different flap configurations.
Kinds of Operation Limits
Describes permitted flight operations (VFR, IFR, etc.).
Fuel Limitations
Details fuel capacity and usable/unusable fuel quantities.
Placards
Information displayed on pilot and baggage placards.
Section 3 Emergency Procedures
Introduction
Provides checklists and amplified procedures for emergencies.
Airspeeds for Emergency Operation
Lists recommended airspeeds for emergency procedures.
Engine Failures
Procedures for engine failure during takeoff and flight.
Forced Landings
Steps for emergency and precautionary forced landings.
Fires
Procedures for handling fires during start and in flight.
Icing
Steps for inadvertent icing encounters.
Landing with a Flat Main Tire
Procedure for landing with a flat tire.
Electrical Power Supply System Malfunctions
Troubleshooting for over-voltage and discharge issues.
Engine Failure
Amplified procedures for engine failure scenarios.
Forced Landings
Amplified procedures for forced landings and ditching.
Emergency Operation in Clouds
Procedures for instrument flying emergencies.
Recovery from a Spiral Dive
Steps to recover from a spiral dive.
Flight in Icing Conditions
Guidelines for avoiding and handling icing.
Spins
Recovery procedure for inadvertent spins.
Rough Engine Operation or Loss of Power
Troubleshooting for engine roughness and power loss.
Section 4 Normal Procedures
Introduction
Outlines procedures for normal flight operations.
Speeds for Normal Operation
Lists recommended speeds for takeoff, climb, and landing.
Preflight Inspection
Detailed checklist for preflight walk-around inspection.
Before Starting Engine
Steps to perform before starting the engine.
Starting Engine
Procedures for starting the engine.
Before Takeoff
Checklist before initiating takeoff.
Takeoff
Procedures for normal and short field takeoffs.
Enroute Climb
Techniques for normal, best rate, and best angle climbs.
Cruise
Guidelines for cruise flight operations.
Before Landing
Steps to perform before landing.
Landing
Procedures for normal and short field landings.
Balked Landing
Procedure for a go-around during landing.
After Landing
Steps to perform after landing.
Securing Airplane
Procedures for securing the aircraft after flight.
Starting Engine
Amplified procedures for engine starting.
Taxiing
Procedures for taxiing and ground handling.
Cold Weather Operation
Procedures for operating in cold weather.
Noise Abatement
Recommendations for minimizing aircraft noise.
Section 5 Performance
Introduction
Overview of performance data and chart usage.
Use of Performance Charts
Guidance on interpreting performance charts.
Sample Problem
Example calculation for flight performance data.
Takeoff
Takeoff distance data considering altitude, temp, and wind.
Cruise
Cruise performance data for various altitudes and powers.
Fuel Required
Calculation of total fuel needed for a flight.
Landing
Landing distance data for different conditions.
Airspeed Calibration
Table relating indicated to calibrated airspeed.
Temperature Conversion Chart
Chart for converting Celsius to Fahrenheit.
Stall Speeds
Table of stall speeds based on weight, flaps, and bank.
Takeoff Distance
Detailed takeoff distance chart.
Rate of Climb
Chart showing climb rates at different altitudes and temps.
Time, Fuel, and Distance to Climb
Data for climb performance.
Cruise Performance
Table of cruise performance data.
Range Profile
Charts showing aircraft range at various conditions.
Endurance Profile
Charts showing aircraft endurance at various conditions.
Landing Distance
Detailed landing distance chart.
Section 6 Weight & Balance/ Equipment List
Introduction
Procedures for establishing empty weight and moment.
Airplane Weighing Procedures
Step-by-step guide for weighing the aircraft.
Weight and Balance
Information on operating within weight and CG limits.
Loading Arrangements
Diagrams showing seat and baggage load positions.
Baggage Loading and Tie-Down
Guidelines for securing baggage.
Cabin Height Measurements
Dimensions of the cabin interior.
Sample Loading Problem
Example of calculating aircraft loading.
Loading Graph
Graph for determining load moments.
Center of Gravity Moment Envelope
Chart showing acceptable CG ranges.
Center of Gravity Limits
Graphical representation of CG limits.
Equipment List
Comprehensive list of available aircraft equipment.
Section 7 Airplane & Systems Descriptions
Introduction
Description of airplane systems and operation.
Airframe
Details of the aircraft's structural components.
Flight Controls
Explanation of the aileron, rudder, and elevator controls.
Trim System
Operation of the elevator trim tab system.
Instrument Panel
Layout and function of instruments and avionics.
Ground Control
Procedures for taxiing and airplane movement.
Wing Flap System
Operation of the wing flap system.
Landing Gear System
Description of the landing gear and brakes.
Baggage Compartment
Information on the baggage compartment and its use.
Seats
Description of seat types and adjustments.
Seat Belts and Shoulder Harnesses
Usage of seat belts and harnesses.
Entrance Doors and Cabin Windows
Operation of doors and windows.
Control Locks
Function and use of the control lock.
Engine
Overview of the aircraft engine.
Engine Controls
Operation of throttle and mixture controls.
Engine Instruments
Monitoring engine operation with instruments.
New Engine Break-In and Operation
Recommendations for new engine operation.
Engine Oil System
Description of the engine oil system.
Ignition-Starter System
Operation of the ignition and starter.
Air Induction System
How the engine receives air.
Exhaust System
Details of the exhaust system.
Carburetor and Priming System
Function of the carburetor and primer.
Cooling System
Description of the engine cooling system.
Propeller
Specifications of the propeller.
Fuel System
Operation of the fuel system.
Brake System
Description of the brake system.
Electrical System
Overview of the aircraft's electrical system.
Over-Voltage Sensor and Warning Light
Protection against over-voltage conditions.
Circuit Breakers and Fuses
Protection for electrical circuits.
Ground Service Plug Receptacle
Use of external power sources.
Lighting Systems
Operation of exterior and interior lights.
Pitot-Static System and Instruments
Function of pitot-static system and instruments.
Vacuum System and Instruments
Operation of vacuum system and related instruments.
Stall Warning System
How the stall warning system works.
Avionics Support Equipment
Optional avionics like audio panels.
Section 8 Airplane Handling, Service & Maintenance
Introduction
Recommended procedures for handling and servicing.
Identification Plate
Location of aircraft identification information.
Owner Follow-Up System
Program for owner notification of service updates.
Publications
List of available pilot and aircraft publications.
Airplane File
Checklist of required documents for the airplane file.
Airplane Inspection Periods
FAA required inspections and progressive care.
Cessna Progressive Care
Program for scheduled inspections and maintenance.
Cessna Customer Care Program
Details of warranty and initial inspections.
Pilot Conducted Preventive Maintenance
Limited maintenance pilots can perform.
Alterations or Repairs
Requirements for aircraft modifications.
Ground Handling
Procedures for towing and parking.
Tie-Down
Proper procedure for securing the aircraft outdoors.
Jacking
Procedures for jacking the airplane.
Leveling
Method for leveling the airplane.
Flyable Storage
Procedures for short-term storage.
Servicing
General servicing requirements and intervals.
Engine Oil
Grade, capacity, and change intervals for engine oil.
Fuel
Approved fuel grades and tank capacities.
Landing Gear
Tire pressures and shock strut filling.
Cleaning and Care
Procedures for cleaning windows and painted surfaces.
Propeller Care
Maintenance and inspection of the propeller.
Engine Care
Cleaning and maintenance of the engine.
Interior Care
Cleaning upholstery, carpets, and trim.
Section 9 Supplements (Optional Systems Description & Operating Procedures)
Introduction
Overview of optional system supplements.
Emergency Locator Transmitted (ELT)
Description, limitations, and procedures for the ELT.
Cessna 300 Nav/Com (Type RT-308C)
Description of the Nav/Com system.
Cessna 300 Nav/Com (720-Channel - Type RT-328T)
Description of the 720-channel Nav/Com system.
Cessna 300 ADF (Type R-546E)
Description of the Automatic Direction Finder.
Cessna 300 Transponder (Type RT-359A) and Optional Altitude Encoder (Blind)
Operation of transponder with blind altitude encoder.
Cessna 400 Marker Beacon (Type R-402A)
Description of the marker beacon system.
Cessna 400 Glide Slope (Type R-443B)
Description of the glide slope receiver.

Table of Contents

Save PDF