Zone2 Speaker Out Connections; Connecting The Power Supply Cord - Denon AVR-1706 Operating Instructions Manual

ENGLISH
Connecting Other Sources

ZONE2 speaker out connections

• When the power amplifier is assigned to the ZONE2 output channel at "Power Amp
Assignment", the surround back speaker terminals can be used as the ZONE2 speaker out
terminals ( page 35).
• The connections diagram below is an example for when the surround back speaker is assigned
to the ZONE2 stereo 2 channel.
In this case, surround back speaker out can not be used for MAIN ZONE.
Subwoofer
IN
Connection terminal
for subwoofer with
built-in amplifier
(subwoofer), etc.
( L ) ( R )
< > > <
Front speaker
systems (B)
Center Surround speaker
speaker systems
( L )
> < >
> <
( L )
( L ) ( R )
< > > <
>
Front speaker ZONE2 speaker
systems (A) systems
NOTE:
• The settings must be
changed to use this
speaker for ZONE2
( page 43).

Connecting the power supply cord

( R )
<
NOTE:
• Only use the AC OUTLETS for connecting audio equipment. Never use it for hair driers, TVs
or other electrical appliances.
( R )
< > <
15
ENGLISH
Connecting Other Sources
AC outlet (Wall)
AC 120 V, 60 Hz
AC OUTLETS
• SWITCHED (total capacity – 120 W (1 A.))
The power to this outlet is turned on and off
in conjunction with the POWER switch on the
main unit, and when the power is switched
between on and standby from the remote
control unit.
No power is supplied from this outlet when
this unit's power is at standby. Never connect
equipment whose total power consumption
exceeds 120 W (1 A.).