Denon AVR 3802 Operating Instructions Manual page 13

4
Once "Meter" or "Feet" is selected in Step 3,
the Delay Time screen appears automatically.
5
Select the speaker to be set.
TUNING
BAND MODE
TUNING
6
Set the distance between the
TUNING center speaker and listening
position.
BAND MODE
The distance changes in units
TUNING
of 0.1 meters (1 foot) each
time the button is pressed.
Select the value closest to the
measured distance.
If "Yes" is selected for "Default", the settings are
automatically reset to the default values.
Please note that the difference of distance for every speaker
should be 4.5 m (15 ft) or less. If you set an invalid distance,
a CAUTION notice, such as screen right will appear. In this
case, please relocate the blinking speaker(s) so that its
distance is no larger than the value shown in highlighted line.
7
Enter the setting.
ENTER
The System Setup Menu reappears.
SHIFT
The AVR-3802 automatically sets the optimum surround delay time for the listening room.
NOTES:
• If the distance unit is changed after the delay time is set, the settings are reset to the factory default values
(see page 9).
Example: When the distance is set to
3.6 m for the center speaker
Setting the channel level
• Use this setting to adjust so that the playback level between the different channels is equal.
• From the listening position, listen to the test tones produced from the speakers to adjust the level.
• The level can also be adjusted directly from the remote control unit. (For details, see page 27.)
• When using both surround speakers A and B, their playback levels can be adjusted separately.
1
At the System Setup Menu select "Channel Level".
TUNING
BAND MODE
TUNING
2
Switch to the Channel Level screen.
ENTER
SHIFT
3
Select "Test Tone Mode".
TUNING
BAND MODE
TUNING
4
Select the mode.
TUNING Select "Auto" or "Manual".
• Auto:
BAND MODE
Adjust the level while listening to the test tones produced
TUNING
automatically from the different speakers.
• Manual:
Select the speaker from which you want to produce the
test tone to adjust the level.
5
Select "Surr. Sp.", then select the surround speaker(s) from which
TUNING
TUNING you want to produce the test tone (A, B or A+B).
• Surr. Sp.: A
BAND MODE
BAND MODE
Adjusts the balance of the playback level between the channels
TUNING
TUNING
when using surround speaker A.
• Surr. Sp.: B
Adjusts the balance of the playback level between the channels
when using surround speaker B.
• Surr. Sp.: A+B
Adjusts the balance of the playback level between the channels
when using surround speakers A and B at the same time.
The "Surr. Sp." can only be selected when both surround
speakers A and B have been selected at the "Speaker
Configuration" (when both A and B have been set to "Large" or
"Small").
6
Select "Test Tone Start".
TUNING
BAND MODE
TUNING
ENGLISH
Example: When the "Auto" mode is selected
13