How To Spot A Sub-Pixel Defect; Hp Pixel-Defect Standards; Hp Specifications - HP 455031-L22 - Intel Quad-Core Xeon 2.13 GHz Processor Upgrade Introduction Manual

How to spot a sub-pixel defect

Due to their tiny size relative to the screen, defective sub-pixels can be extremely
hard to see. A defect in a sub-pixel is, visually, a single, tiny spot that is so small, it
may be visible only if you display it against a background that specifically contrasts
with the defective sub-pixel hue.
Because they appear brighter to the human eye, defective green sub-pixels may be
easier to spot than defective red or blue ones. Sub-pixel defects are also easier to
spot when they are clustered together in a single area. If all three sub-pixels in the
same pixel fail simultaneously, you are more likely to detect the resulting light or
dark pixel. However, since HP specifications require that TFT panels not have any
complete pixel defects (i.e., all three sub-pixels defective), HP customers are not
likely to encounter this situation.
To locate defective sub-pixels, the monitor should be viewed under normal
operating conditions, in normal operating mode at a supported resolution and
refresh rate, from a distance of approximately 20 inches (51 cm). The following
standards show the typical conditions under which HP scans for pixel defects:
Viewing distance of approximately 14 inches (36 cm)

Ambient illumination of 300 to 500 lux (average room lighting can vary from

60 to 600 lux; typical museum lighting is 50 lux).
Viewing angle of 70 to 110 degrees horizontal and 80 to 100 degrees vertical


HP pixel-defect standards

Since some degree of sub-pixel defects are inevitable, all manufacturers find it
necessary to tolerate a minimal number of sub-pixel defects in their products.
Replacing a panel with just a few minor sub-pixel defects is not recommended,
since the replacement unit may also have a similar number of defects.
Historically, HP has maintained stringent manufacturing specifications for pixel
defects, and it has been tightening those specifications over time.

HP specifications

HP pixel defect specifications continue to be refined, but will always represent the
best panel quality standards which can reasonably be achieved, consistent with
expected panel yields, the need to deliver products at competitive costs, and most
importantly the goal of producing high-quality images on our displays. In a
simplified format, the pixel defect specifications are as follows:
Table 1. This policy applies for HP monitors manufactured before May 2009:
Bright sub-pixel defects:
Dark sub-pixel defects:
Total sub-pixel defects:
Full pixel defects:
3 maximum
5 maximum
5 maximum
0 allowed
5