ESPRIT 728 ultra Programming Manual

Installer Code (Default - 728 Ultra: 282828; 738 Ultra: 383838)
Full access to programming, except user access codes (PINs). No access to arming/disarming. Use only numeric keys from [0] to [9].
Zone Recognition
Device connected to which input?
Control Panel
Input 1 =
Input 2 =
Input 3 =
Input 4 =
Input 5 =
Input 6 =
Input 7 =
Input 8 =
Keypad
Zone 1 =
Zone 2 =
Streamlined Section Programming
This is an alternate method to Hex Programming (see page 2). Addresses 000 to 043 and 300 to 527 are grouped into 68 sections where
each section contains four addresses (i.e. section 00 = addresses 000 to 003). Using this method allows you to program 8 digits
(4 addresses) without having to exit and re-enter addresses.
The keypad will not display the current data in the Streamlined Section Programming method.
1. Press [
2. The [
3. Enter 2-digit [
4. The [
5. Enter 8-digit [
6. The keypad will beep to indicate that the section has been programmed, data is saved and the
software has advanced to the next section.
7. Return to step 4 or press [
System Programming Guide
Software Versions 4.4 (728ULT) and 4.1 (738ULT)
Table 1: Zone Recognition
Table 2: Streamlined Section Programming Method
] + [
ENTER INSTALLER CODE
] and [2 ] keys will flash to indicate you are in programming mode (LED keypad only).
ENTER ND
] (00 to 67).
SECTION
] key will remain on while the [2
ENTER
] to program the section.
DATA
CLEAR
Esprit 728 Ultra & 738 Ultra - 1 - Programming Guide
&
728 Ultra 728 Ultra
No ATZ With ATZ
Zone 1 Zones 1 & 2
Zone 2 Zones 3 & 4
Zone 3 Zones 5 & 6
Zone 4 Zones 7 & 8
N/A N/A
N/A N/A
N/A N/A
N/A N/A
Zone 5 Zone 9
Zone 6 Zone 10
] (Default - 728 Ultra: 282828; 738 Ultra: 383838) + [7].
] key will be off (LED keypad only).
ND
] to exit programming mode.
738 Ultra 738 Ultra
No ATZ With ATZ
Zone 1 Zones 1 & 9
Zone 2 Zones 2 & 10
Zone 3 Zones 3 & 11
Zone 4 Zones 4 & 12
Zone 5 Zones 5 & 13
Zone 6 Zones 6 & 14
Zone 7 Zones 7 & 15
Zone 8 Zones 8 & 16
Zone 9 Zone 17
Zone 10 Zone 18