Related Manuals for UHL X3-2
Summarization of Contents
Device Connections
Backpanel Ports Overview
Details the various input and output jacks on the rear panel of the X3.
Specific Input/Output Details
Explains the 11-pin rotary, pedal, and foot switch connections.
Getting Started: Power and Audio Setup
Audio Connections
Guides on connecting audio outputs to amplifiers or mixers for stereo or mono sound.
Console Controls Overview
Drawbars
Adjust the basic harmonics and sound shaping options of the X3 organ.
Percussion Settings
Adds a percussion signal to the note, affecting attack characteristic.
Vibrato and Chorus Effects
Selects and switches vibrato or chorus effects for upper/lower manuals.
Rotary Speaker Simulation
Replicates the sound of a rotary speaker cabinet, adjustable via controls.
Reverb and Hall Effects
Features a spring reverb with four levels (OFF, REV 1, REV 2, REV 3).
Keyboard Split Operation
Allows keyboard splitting for lower/upper manuals with selectable split points.
Common Presets
Provides 14 presets storing all sound settings like percussion, reverb, and routing.
Audio Output Configuration
Selectable output signals routed to MAIN OUT/AUX OUT jacks.
Tone Control
Adjusts high frequencies to accentuate key click and percussion.
Volume and Overdrive Controls
Manages volume and post-overdrive level for dynamic tube sound.
MIDI Interface
MIDI Input Ports
Connects controller keyboards or MIDI pedals for lower manual and pedal bass.
MIDI Output Port
Connects sound modules or synthesizers, allowing the X3 to act as a controller.
Menu System and Parameter Settings
Save Mode Operation
Permanently stores parameter changes by pressing the Data Entry knob for 2 seconds.
Factory Presets Management
Manages 14 presets for upper/lower manuals, selectable via Up/Down and Data Entry knob.
Change Factory Presets
Allows replacing factory presets with user-defined sounds and saving them.
Transpose Function
Adjusts the pitch of the organ by semitones up or down.
Audio Configuration Options
Configures output signal routing for different audio jack configurations.
Vibrato/Chorus Group Settings
Adjusts detailed parameters for vibrato and chorus effects.
Percussion Group Settings
Fine-tunes percussion levels, decay rates, and volume.
Generator Group Settings
Adjusts core sound generation parameters like volume, flutter, and leakage.
Reverb Group Settings
Adjusts individual levels for Hall 1, Hall 2, and Hall 3 reverb effects.
Rotary Simulation Group Settings
Adjusts rotary speed, acceleration, and balance for simulation.
Need help?
Do you have a question about the X3-2 and is the answer not in the manual?
Questions and answers