Compaq 207590-B21 - Power Distribution Unit Strip Quick Install Manual

P D
OWER
U K
NIT IT
Quick Installation Guide for
Rack-Mounted Power Distribution Unit (PDU)
Low Voltage Model
Open Guide Completely Before
Beginning Installation Procedures
Printed on recycled paper
NOTICE
The information in this publication is subject to change without notice.
COMPAQ COMPUTER CORPORATION SHALL NOT BE LIABLE FOR
TECHNICAL OR EDITORIAL ERRORS OR OMISSIONS CONTAINED HEREIN,
NOR FOR INCIDENTAL OR CONSEQUENTIAL DAMAGES RESULTING FROM
THE FURNISHING, PERFORMANCE, OR USE OF THIS MATERIAL. THIS
INFORMATION IS PROVIDED "AS IS" AND COMPAQ COMPUTER
CORPORATION DISCLAIMS ANY WARRANTIES, EXPRESS, IMPLIED OR
STATUTORY AND EXPRESSLY DISCLAIMS THE IMPLIED WARRANTIES OF
MERCHANTABILITY, FITNESS FOR PARTICULAR PURPOSE, GOOD TITLE
AND AGAINST INFRINGEMENT.
This publication contains information protected by copyright. No part of
this publication may be photocopied or reproduced in any form without
prior written consent from Compaq Computer Corporation.
©
2000 Compaq Computer Corporation
Compaq, Registered U.S. Patent and Trademark Office.
COMPAQ POWER DISTRIBUTION UNIT KIT
QUICK INSTALLATION GUIDE FOR RACK-MOUNTED POWER DISTRIBUTION DEVICE
Second Edition (November 2000)
Part Number 215890-022
Compaq Computer Corporation
ISTRIBUTION
About This Device
This guide serves as an outline to assist qualified personnel with the installation
of the Compaq Power Distribution Unit (PDU).
The input voltage for this model PDU is 100VAC to 127VAC. This PDU
includes the following features:
Mounts in either 0U or 1U configuration, offering maximum flexibility for
utilizing rack space.
NOTE: 1U mounting kit sold separately (part number 215852-B21).
This model (207590-D71) provides 12 receptacles on 4 circuit breakers.
This PDU is used with UL listed and CSA certified information technology
equipment.
Regulatory Compliance Information
All regulatory certifications for this product were obtained under the following
agency series number. The corresponding part model number is shown.
207590-D71 EO3021
Important Safety Information
Read Before Installing Product
Please refer to the Important Safety Information (guide included with the PDU
kit) before installing this product.
WARNING: There is a risk of personal injury from electrical
shock and hazardous energy levels. The installation of options
and routine maintenance and service of this product must be
performed by individuals who are knowledgeable about the
procedures, precautions, and hazards associated with AC power
products.
IMPORTANT SAFETY INSTRUCTIONS
SAVE THESE INSTRUCTIONS - This Quick Installation Guide contains
important instructions for the rack-mounted PDU that should be followed during
installation.
Kit Contents
Power Distribution Unit
Assembly, 0U mounting hardware
Mounting brackets - 0U (2)
Screws 1 mounting brackets to unit (6) [2 extra]
Screws 3 mounting unit to rack (6) [2 extra]
Cord retention hardware
Cord retention bracket
Screws 4 mounting bracket to unit (3) [1 extra]
Tie wraps (15) [several extra]
Installing the Cord Retention Bracket
1
Align the cord retention bracket with screw holes in unit. Use screws 4 to attach
bracket to the bottom of the unit.
4
4