How To Use Your Dryer; The Controls - Creda HB37513 Instruction Book

How to use your dryer

1. Plug in, switch
on electricity.
3. Open the door.
Check that the fluff
filter is clean (see
section How to
remove and clean
the fluff filter).
5. Lock the door
handle (where
lock is fitted). The
edge of a suitable
coin can be used
to rotate the lock.
7. Select drying programme
required.
Automatic drying, average loads
Automatic drying, large loads
The dryer will start (see section "The
Controls").
9. Switch off electricity and
remove plug from socket.
Lock the door to prevent
access (Where lock is fitted).
About 10 minutes before the programme is completed, the heating elements
Cool
will be switched off, and the programme enters the final 'Cool Tumble' phase.
Tumble
During this phase the fabric is cooled. You should always allow the dryer to
Phase
complete this phase.
By opening the door you can check the dryness of the load as often as you
wish, and if you want to remove some items before they are fully dry. (This is
particularly useful for a mixed load where you want to iron some items but
others are to be fully dried).
Never switch the dryer off with a hot load in the drum.
You must terminate every programme with the Cool Tumble Phase.
WARNING: WHEN
SWITCHING ON
OR OFF, PLEASE
ENSURE THAT
YOUR HANDS
ARE DRY
6. Select the
relevant heat setting (see
section "The Controls").
Automatic programs
LOCKED
will NOT function on
Low Heat
8. When finished, unlock
and open the door and take
e
out the laundry. Clean and
replace the fluff filter.
E
UNLOCKED
LOCKED
2. Sort your laundry
(see section "Sorting
Your Laundry")
4. Load the dryer
placing the clothes
carefully in the drum
pushing them well
towards the back
and away from the
door seal. Close the
door.
WARNING: WHEN SWITCHING ELECTRICITY
ON OR OFF, PLEASE ENSURE THAT YOUR
HANDS ARE DRY.
Button IN
or Rocker DOWN
HIGH HEAT
Button OUT
or Rocker UP
LOW HEAT
9