LaCie 301421U - 2big Network NAS Server User Manual page 60

LaCie 2big Network
User Manual
Problem
■
The drive is not
recognized by
the computer.
The drive doesn't
appear on the
network.
Question to Ask
■
Did you follow the correct in-
stallation steps for the specific
interface?
Are both ends of the interface
cable firmly connected?
By default the 2big Network is configured to retrieve its IP address from a DHCP server. If your
network is managed by a DHCP server and you cannot access your 2big Network, try checking your
DHCP server's log. To get the IP address, run the LaCie IP configurator software tool, which is
located on the LaCie Storage Utilities CD-ROM. If your network is NOT managed by a DHCP
server, the 2big Network uses its default IP address, which is 19X.x6X.x.100. To change this IP ad-
dress, use the LaCie IP Configurator software tool.
Is the IP address properly set?
Is your network DHCP en-
abled?
Are you using AppleTalk under
Mac OS 9.x?
Solution
■
Review the installation steps (chapter 3). The two cables cannot
be connected at the same time.
Disconnect the interface cable, wait 10 seconds and then re-
❖
connect.
Ensure that the interface connectors are properly aligned. The
❖
interface cables can only be inserted one way. Make sure that
they are correctly oriented.
Check that the interface connectors are straight and fully seat-
❖
ed in the interface ports.
Only use certified interface cables, such as the cables provided
❖
with your LaCie drive. If you have followed all of these steps
and the drive is still not recognized, shut down your computer,
wait 3 to 5 minutes, restart your computer and try again. In
the event that the drive is still not recognized, take the drive
to another computer and attempt to connect the drive. If the
drive is not recognized on another computer, please contact
your LaCie reseller or LaCie Customer Support.
For more information, please see section 4.
Storage.
If your network is DHCP enabled, please refer to sections
Connecting with LaCie Ethernet Agent
the IP Configurator Wizard. If your network is not DHCP en-
abled, you will need to manually configure the address; please see
section 2.5, Configuring the 2big Network on a LAN Without a
DHCP Server.
If you are using AppleTalk under Mac OS 9.x, ensure that the
LaCie 2big Network and the other clients on the network are in
the same AppleTalk zone.
Troubleshooting
page 
Accessing the Shared
2.3,
or 2.4, Connecting with