HARMSCO BF105 BKMSC Installation And Operation Manual

INSTALLATION AND OPERATION MANUAL
UPFLOW SWIMMING POOL CARTRIDGE FILTER
CARTRIDGE CLEANING INSTRUCTIONS
May be cleaned and reused before replacement is necessary.
Cartridge cleaning is necessary only when flow falls below that required or
when pressure increase over start-up pressure exceeds 10 pounds.
INSTRUCTIONS FOR CLEANING CARTRIDGES
See Page 4 on how to remove and replace cartridge(s) for cleaning.
Remove rim gasket to prevent damage during cleaning.
Normal Cleaning Procedure.
Normal cleaning is done by using a pressure nozzle on the end of your garden
hose. Direct jet spray at cartridges on an angle to remove dirt.
Special Cleaning Procedures.
To be used only when normal procedure is insufficient to return cartridge to
normal filter runs.
Removing Oils From Cartridges. If oils coat cartridges and cause reduced flow, this
1
material may be removed by soaking cartridges in a solution of 2 lb. Tri-sodium Phosphate
to 10 gallons of water or a Tri-sodium Phosphate based product. Usually 12 hours soaking time
will break oil coating from cartridge. Enzyme products are known to release oils from cartridge
media and in some cases may eliminate the need for soaking. Tri-sodium Phosphate and
enzyme products are available at most swimming pool distributors and retail locations. Repeat
Normal Cleaning Procedure.
Removing Algae From Cartridges. If algae coats the cartridges and causes reduced flow,
2
soak cartridges in a solution of 2 lb. Tri-sodium Phosphate to 10 gallons of water. Add 1 pint
of swimming pool chlorine to kill the algae. Soak for one hour. Check pool chemistry for cause of
algae growth.
Removing Calcium Or Mineral Deposits. ***Caution*** Do not use muriatic acid on
3
cartridges until all oils have been removed as in step #1 above. Make sure all previously
used products have been thoroughly rinsed from cartridges.
If calcium deposits are present, perform operation #1 above. Rinse - then, in a solution of 1 part
muriatic acid to 20 parts water, soak until bubbling action stops. Use a plastic garbage
container or similar vessel. Check pool chemistry for high PH or Alkalinity. Repeat Normal
Cleaning Procedure.
The only exception to the above procedures are with the use of biguanides (i.e. Baquacil,
4
SoftSwim or other similar sanitizer). When using a biguanide, always soak the cartridge
with muriatic acid first (as described in #3), and then soak in Tri-sodium Phosphate and water,
(as described in #1).
Heed all manufacturer's posted instructions, warnings and cautions
HARMSCO
HARMSCO CARTRIDGES
when using any product.
®
®