Denon RCD-N7 Owner's Manual page 52

ENGLISH
Symptom Cause
The TV sound is • Other digital audio signals than
not output. 2 channel linear PCM cannot
be input through AUX IN 3
(OPTICAL) terminal of this unit.
"No Network • The network is not properly set
Connection" is up.
displayed.
GRemote controlH
Symptom Cause
Set does not • Batteries are worn.
work properly • You are operating outside of the
when remote specifi ed range.
control operated. • Obstacle between main unit and
remote control.
• The batteries are not inserted
in the proper direction, as
indicated by the polarity marks
in the battery compartment.
• The set's remote control sensor
is exposed to strong light (direct
sunlight, fl uorescent light, etc.).
48
Countermeasure Page
–
• When you try to input digital
audio signals other than 2
channel linear PCM to this unit,
set the digital audio output
setting of the TV to 2 channel
PCM.
For details, see the operating
instructions of the TV.
27
• Perform "Network First Setup."
• Select a source other than the
network function.
12
Countermeasure Page
• Replace with new batteries. 4
• Operate within the specifi ed 4
range.
• Remove the obstacle. –
• Insert the batteries in the 4
proper direction, following the
polarity marks in the battery
compartment.
• Move the set to a place in which 4
the remote control sensor will
not be exposed to strong light.
GCDH
Symptom Cause
"Unsupported" • The disc is not properly loaded.
is shown on the
display even
though a CD is
loaded.
Disc does not • The disc is dirty or scratched.
1/3
play when
button is pressed.
A specifi c part • The disc is dirty or scratched.
of a disc is not
played.
A CD-R or CD-RW • The disc has not been fi nalized.
disc cannot be • The recording conditions are bad
played. or the quality of the disc itself
it poor.
MP3 and WMA • The fi le formats, extensions or
fi les cannot be settings made when the disc
played. was created are not compatible
with this unit.
GTunerH
Symptom Cause
Continuous noise • Antenna cable is not properly
is heard when connected.
receiving FM
programs.
Hissing or • This may be noise from a TV or
continuous noise interference from a broadcast
is heard when station.
receiving AM
programs.
Countermeasure Page
• Reload the disc. 3
• Wipe the disc clean or replace 3
the disc.
• Wipe the disc clean or replace 3
the disc.
• Finalize the disc then play it. 3
• Use a properly recorded disc. –
• Create discs with fi le formats, 43
extensions or settings
compatible with this unit.
Countermeasure Page
• Connect the antenna cable 7
properly.
• Connect an outdoor antenna. –
• Turn off the TV. –
• Change the position and 7
direction of the AM loop
antenna.