Simrad PI CONFIGURATOR SW 4.10 - SOFTWARE RELEASE NOTE REV D Release Note

Software release note
Simrad PI Configurator SW 4.10

Introduction

This document describes the
release of software version 4.32 for
the application.
PI Configurator
The PI Configurator runs on a
standard desktop or laptop computer
set up with
Windows® XP®
operating systems.
Windows® 7
The application is used to define
transmission channels and update
rates on the PI and PS sensors.
In order to interface the sensor,
you need a special interface unit, the
. This interface device can be
PI CIC
obtained from Simrad.

Changes with SW 4.32

The following changes have been
implemented.
• Core software redesigned.
• Implemented support for new
sensors.
• Released for Windows® 7.
• Bug fixes.

PI CIC software driver

A dedicated driver must be
installed on your computer to use the
interface unit. This driver can
PI CIC
be downloaded from our website:
http://www.simrad.com.
A new version 2.06.02 is now
available to support Windows® 7.

Do I need to upgrade?

This new version of the PI
Configurator software will - when
used with the interface unit
PI CIC
- handle all old and current PI and
PS sensors. The latest hardware
and software developments put to
T E C H N O L O G Y
or
use in the sensors will also require
this combination. Older versions of
the PI Configurator will not work
on the latest sensors. The old types
of interface cables will also prove
unoperational on the latest sensor
electronics.
For these resons, we strongly
advice all users to upgrade to the
latest software version, and to put the
unit to use.
PI CIC
F O R S U S T A I N A B L E

Documentation

The PI Configurator instruction
manual and on-line help has been
revised. The manuals are now also
available in Spanish.
Turn the page for more information!
www.simrad.com
F I S H E R I E S