INSTRUCTIONS
PRODUCT
OR
YOUR
Step 1
Connect the flexible
hose to the pump outlet.
Adjust the pump flow rate to achieve the desired effect
and to minimize any splashing. Splashing can occur if the
flow rate is too high or the feature is too full. The flow rate
can be increased or decreased by moving the flow rate
control slider on the pump body. Moving the switch
towards (+) will increase the flow rate and moving
it towards (-) will decrease it.
©Copyright 2021, Design Toscano, Inc.
1 . 8 0 0 . 5 2 5 . 0 7 3 3
DESIGNTOSCANO.COM
Earth Witness Buddha Illuminated Garden Fountain
Step 2
Fill the reserviour with water
and take a note of the level that
the water reaches for future
reference when topping off.
Step 3
Plug in and switch on, after
short while the water will
start to flow.
WARNING
Never turn on the pump before the
fountain is full of water. Also do not
let the water level fall below the top
of the pump as the pump will become
damaged if run without water. Fountain
should be placed on a level surface.
T H A N K YOU
PURCHASE
OR
YOUR
QN-164001
Need help?
Do you have a question about the QN-164001 and is the answer not in the manual?
Questions and answers